An exploratory study of knock intensity in a large-bore heavy-duty methanol engine
Ward Suijs,Rik De Graeve,Sebastian Verhelst
DOI: https://doi.org/10.1016/j.enconman.2024.118089
IF: 10.4
2024-01-22
Energy Conversion and Management
Abstract:With current interest from the heavy-duty industry in high-octane renewable fuels like methanol, the currently used compression ignition engines will have to be adapted to dual-fuel (DF) type combustion systems or replaced by spark-ignition (SI) engines. Since both DF and SI engines are characterized by a premixed air–fuel mixture, there is a risk that part of the unburned mixture auto-ignites before the flame front can reach it, leading to engine knock. Accurate control of this abnormal combustion phenomenon is necessary and can be done by means of the in-cylinder pressure signal. The purpose of this work is to provide a framework for predicting and evaluating the intensity of knock in large-bore methanol fueled engines based on the knowledge of an automotive sized counterpart. At first, the band-pass filter, needed to focus on the knock-induced pressure oscillations, has to be greatly adjusted for engine size. Second, an appropriate knock metric and associate threshold value is needed. The performance of five conventional knock intensity metrics ( MAPO , IMPO , AE , MVTD and HRR ) was investigated at the 50 %, 75 %, and 87.5 % load points of a 256 mm bore methanol-diesel medium speed engine. With knock threshold values being derived from a small-bore (B = 82.55 mm), methanol fueled SI engine, the calculated knock intensities were well above the thresholds even for the non-knocking cycles. To counter this, a set of five normalized knock intensity metrics were tested as well. From these, the signal-to-noise ratio metric MAPOnorm showed the most promising results. The R 2 values agreed with the findings of the conventional MAPO method, and, with a normalized knock threshold value of 8.07, it could distinguish knocking cycles in both the small bore and the large-bore engine, although additional engine-specific calibration would be recommended.
energy & fuels,thermodynamics,mechanics