Abstract:The reason that p-GaN gate normally-off high electron mobility transistor (HEMT) device is able to draw prevail interests is not only for its outstanding electric properties of low on-resistance and high thermal conductivity, but also for its applications under high frequency and high voltage. In HEMT devices, the setting of Al component in the AlGaN barrier layer is a key parameter to affect the formation of two-dimensional electron gas (2DEG) at the AlGaN/GaN heterojunction, and therefore directly determines the performance of the devices. This paper uses the Atlas module of the Silvaco-TCAD software to design and simulate p-GaN gate normally-off HEMT devices to investigate the effect of Al mole fraction content in the AlGaN barrier layer on the electrical performance, as well as the causes in terms of the conduction band energy structure diagram. The results show that the threshold voltage of the HEMT device decreases, the maximum saturation drain current increases, and the peak transductance of the HEMT device increases with increasing the Al content. In the off-state (zero gate voltage), the AlGaN/GaN potential well depth becomes deeper as the Al mole fraction increases, resulting in a lower driven force to rebuild the minimized 2DEG concentration in the GaN layer for switching from off-state to on-state, and this leads to a lower threshold voltage. While, in the on-state (5 V gate voltage), the deeper AlGaN/GaN potential well depth as the Al mole fraction increases, the higher of the 2DEG concentration of the GaN layer, leading to a higher maximum saturation output drain current. After optimization, the integrated electrical performance of the HEMT devices has been found best when the Al mole fraction content is about 0.25. The results obtained from the simulations are helpful for the experimental design of p-GaN gate normally-off HEMT devices

Analysis on the CTLM and LTLM Applicability for GaN HEMTs Structure Alloyed Ohmic Contact Resistance Evaluation

Analytical Model for AlGaN/GaN High Electron Mobility Transistor

Temperature Dependence of the Specific Resistance in Ti/Al/Ni/Au Ohmic Contacts on (nh4)2sx Treated N-Type GaN

Measurement of Piezoresistance Coefficient Based on GaN HEMT Micro-Accelerometers

Achieving sub-1 Ohm-mm Non-Recess S/D Contact Resistance in GaN HEMTs Utilizing Simple CMOS Compatible La/Ti/Al/Ti Metal Contacts

Measurement of piezoresistance coefficient with different gate voltages of GaN HEMT micro-accelerometer

Optimization of Contact Resistance and DC Characteristics for AlGaN/GaN HEMTs Utilizing Sub-10 nm Nanohole Etching

Study of the Leakage Current Mechanism in Schottky Contacts to Al0.25Ga0.75N/GaN Heterostructures with AlN Interlayers

Low-Resistance Ta/Al/Ni/Au Ohmic Contact and Formation Mechanism on AlN/GaN HEMT

Modified Transmission Line Model To Investigate Non-Ohmic Contact Behavior And Its Application On Gan

Analysis on the new mechanisms of low resistance stacked Ti/Al Ohmic contact structure on AlGaN/GaN HEMTs

Low Contact Resistance CMOS-Compatible RF GaN-on-Silicon HEMTs

Current-collapse Suppression and Leakage-Current Decrease in AlGaN/GaN HEMT by Sputter-Tan Gate-Dielectric Layer

Hybrid TLM‐CTLM Test Structure for Determining Specific Contact Resistivity of Ohmic Contacts

A Drain–Source Connection Technique: Thermal Resistance Measurement Method for GaN HEMTs Using TSEP at High Voltage

Effect of Device Geometry on Static and Dynamic Performance of AlGaN/GaN-on-Si High Electron Mobility Transistor

Low-Temperature Ohmic Contact Formation in AlN/GaN HEMT Using Microwave Annealing

Numerical Simulation of Two-Dimensional Electron Gas Characteristics of a Novel (inxal1−xn/aln)mqws/gan High Electron Mobility Transistor

An 1-4;nhanced AlGaN/GaN HEMTs Large-Signal Model with Parameter Fxtraction Methodology

Simulation study on electrical properties of p-GaN gate normally-off HEMT devices affected by Al mole fraction in AlGaN barrier layer

Numerical Simulation of AlXGa1-XN/AlN/GaN HEMT