Abstract:The capacities of industrial coal-fired boilers are normally less than 20-30MWe. And these coal-fired boilers of low capacity are facing the severe situation of low efficiency and heavy environmental pollution. Hence, an innovative horizontal circulating fluidized bed (HCFB) boiler was developed to enhance heat efficiency and reduce pollutant emission of industrial boilers in China. The chamber in the HCFB boiler consists of primary combustion chamber, secondary combustion chamber and burnout chamber, which were combined horizontally side by side. To verify the conception of horizontal fluidized circulation and to obtain the characteristic data, a 0.35 MWth coal-combustion HCFB boiler was designed and installed to perform some experiments of combustion and mass circulation. In the boiler there were two mass circulating paths, one is inner circulating through the inertia separator and another was external circulating through the cyclone separator. The connection bottom of the secondary chamber and the burnout chamber was designed as an inertia separator, in which separated and collected solid materials were returned to the primary combustion. In fact the secondary separator was a small cyclone separator connecting to the exit of the burnout chamber. Heat efficiency and separating efficiency of the experimental boiler were measured and analyzed. Furthermore, mass and temperature distribution along the chambers height were also investigated. The results showed that the heat efficiency of the bare boiler was 82%. The mass balance based on ash content was measured and analyzed. Separating efficiency of the inertia separator and cyclone separator was 60% and 99.9%, respectively. It showed that the two stage material separation and circulation enhanced coal combustion in the HCFB boiler and help to minimize the height of the furnace.

Numerical Investigation of the Flow and Combustion in a Horizontal Circulating Fluidized Bed Boiler

Numerical Investigation on Oxy-Combustion Characteristics of a 200 MWe Tangentially Fired Boiler

Numerical Simulations of Flow Structure and Heat Transfer in a Central Jet Bubbling Fluidized Bed

Combustion Modeling Of Cfb Boiler Furnace Based On An Euler-Euler Approach

Modeling of Circulating Fluidized Bed Boiler Performance

Experimental Investigation on a 0.35 MWth Coal-Fired Horizontal Circulating Fluidized Bed Boiler

Particle Population Balance Model for a Circulating Fluidized Bed Boiler

Numerical Simulation of Secondary Air Penetration Depth in a 300 MW Single-furnace Circulating Fluidized Bed Boiler

Modeling Study on Non‐Uniform Lateral Distribution in Large‐Scale Circulating Fluidized Bed Boilers

Numerical Simulation of the Combustion and Pollution Emissions from a 75/th Circulation Fluidized Bed Boiler of Power Plant

Numerical Investigation of Different Burner Arrangement on A Coal-Fired Boiler

Measurement of Heat Transfer in a 465t/h Circulating Fluidized Bed Boiler

Numerical Simulation of the Impact of Secondary Air for a Pant-Leg 300 MW Circulation Fluidized Bed Boiler

Numerical Simulation Of The Combustion Processes In A W-Shaped Boiler Furnace Under Different Operating Conditions

Three-dimensional Full-Loop Numerical Simulation of Co-Combustion of Coal and Refuse Derived Fuel in a Pilot-Scale Circulating Fluidized Bed Boiler

Integrated Numerical Model for Ultra/Supercritical CFB Boilers

Numerical Simulation of Combustion Characteristics of a Corner-tube Gas Boiler

Model Prediction of the Operating Behavior of a Circulating Fluidized Bed Boiler

Experimental Investigation and Model Validation of the Heat Flux Profile in a 300 MW CFB Boiler

Study on Dynamic Behavior of the Combustion System of a Circulating Fluidized Bed Boiler

Comparison of Fully 3-D, Simplified 3-D and 2-D Numerical Simulations on a Circulating Fluidized Bed Boiler