Abstract:The as-laid embedment is a key design element of deep-water pipelines, as it significantly affects the longitudinal and transverse pipe-soil interaction and thermal insulation. Due to the small-amplitude oscillations driven by the sea state as well as lay vessel motions, the as-laid embedment is significantly greater than the predictions derived from static penetration analyses. This paper presents a numerical study into the cyclic embedment behavior of deep-water pipelines in soft clay using a recently developed sequential limit analysis (SLA) technique. It directly models the evolution of model geometry and material properties through a consecutive series of small displacement analyses and incorporates the effect of strain softening and strain rate on soil strength. A rigid plane-strain pipe section is pushed-in-place and then subjected to small-amplitude cyclic lateral displacements, with an accumulated lateral pipe displacement of up to 60 diameters. Careful comparisons between the numerical results with published centrifuge data are provided to demonstrate the robustness of SLA, in terms of pipe invert trajectory and soil resistance, followed by an extensive parametric study investigating the effect of strain rate, strain softening, oscillation amplitude, and loading history. More detailed aspects of the cyclic loading behavior are discussed with reference to soil failure mechanisms and bearing capacity yield envelopes. A strong correlation between accumulated lateral pipe displacement and pipe embedment is identified, regardless of the varying oscillation amplitudes, and soil buoyancy is found to play the most significant role in determining the final pipe embedment. The present study aims to assist the development of a macro-element plasticity pipe-soil model that can be incorporated into simplified three-dimensional (3D) pipeline-seabed models, as well as to promote the application of SLA to model complex large-displacement pipe-soil interaction problems.

A Line Model-Based Fast Boundary Element Method for the Cathodic Protection Analysis of Pipelines in Layered Soils

BEM-ALEM Modeling of Plate–Soil Interaction for Rigid Circular Foundation in Layered Saturated Soils Subjected to Mechanical or Thermal Load

A Simplified Analytical Solution of Pipeline Response under Normal Faulting

An analytical solution for landslide impact on buried continuous pipelines

Modelling lateral pipe-soil interaction on soft clay using large displacement sequential limit analysis

Assessment Model of Pipe–soil Interaction During Large-Amplitude Lateral Displacements for Deep-Water Pipelines

Theoretical Analysis and Numerical Simulation of Large-Diameter and Thin-Wall Pipelines During Ultra-Deep J-Lay Installation

An innovative solution for the dynamic response of buried pipelines in layered transversely isotropic soil under pavement structures

Modeling Cyclic Embedment of Deep-Water Pipelines Using Large Displacement Limit Analysis

An integrated numerical model for wave–soil–pipeline interactions

Pipeline Lateral Buckling Triggered by the Residual Curvature with Tri-Linear Axial Pipe-Soil Interaction

Numerical Analysis of Pipeline in J-Lay Problem

A Refined Analytical Model for Landslide or Debris Flow Impact on Pipelines – Part II: Embedded Pipelines

Modeling pressure pipe embedded in two-layer soil by a half-plane BEM

A Coupled FEM-BEM Methodology to Calculate 3D Earth Surface Potentials Caused by HVDC Return Currents

Buckling Response of Offshore Pipelines under Combined Tension and Bending

Analytical Solution of Pipeline Upheaval Buckling Considering Bi-Linear Axial Pipe-Soil Interaction Model

Modeling and Analysis of Transmission Line Structures Corrosion due to DC Current from Pipeline’s Cathodic Protection

Circuit Model and Application for Influence of DC Ground Electrode on Buried Metal Pipelines

Modeling Direct-Current Interference on Pipelines with Zero Potential at Infinity Through Electric Field Decomposition

Using Finite Element Method for Stress-Strain Evaluation of Commonly Used Buried Pipelines in Fault