Abstract:Thermal insulation materials are widely used in the fields of thermal protection and the energy conservation at high temperature. Thermal conductivity is one of the most important parameters of characterizing the thermal insulation performance of thermal protection materials. Steady state method such as the guarded hot plate method is normally considered as the most accurate method to measure the thermal conductivity of thermal insulation materials, but the temperature range is limited to below 1000 K. Unsteady state method can be employed at higher temperature but the accuracy is lacking of validation. Consequently, thermal verification experiments are usually conducted by heating the front surface of thermal insulation materials to a very high temperature. However, it is difficult to obtain the temperature-dependent thermal conductivity by using the thermal insulation performance measured with a large temperature difference across the material. In this study, a sandwich structure experimental system is built to carry out the thermal insulation performance tests with a large temperature difference at both steady state and transient state. Both uniform temperature layer method and polynomial fitting method are adopted to extract the temperature-dependent thermal conductivity from the large temperature difference test at steady state. A new transient state identification method is proposed based on the niche genetic algorithm to identify the relation between thermal conductivity and temperature from the transient thermal response. The temperature-dependent thermal conductivity of four thermal protection materials are finally obtained. The identification results prove that the proposed transient identification method is reliable and robust.

Measurement Of Thermal Conductivity For Insulation Materials In High Temperature Based On Transient Hot-Plane Method

Thermal Conductivity Measurement of Materials Based on a Transient Hot-Plane Method

Measurement of Thermal Conductivity and Thermal Diffusivity for Materials on Transient Hot-Plane Method

Influence of Participating Radiation on Measuring Thermal Conductivity of Translucent Thermal Insulation Materials with Hot Strip Method

Measurement and identification of temperature-dependent thermal conductivity for thermal insulation materials under large temperature difference

Evaluation of thermal conductivity of insulation materials at high-temperature for longtime

Numerical Study of the Influence of Thermal Radiation on Measuring Semi-Transparent Thermal Insulation Material with Hot Wire Method

Research on insulation properties of high-speed aircraft lightweight heat-resistant materials in high-temperature environment

Insulation Performance of Heat-Resistant Material for High-Speed Aircraft Under Thermal Environments

Influence of Thermal Contact Resistance on Thermal Conductivity Measurement with a High-Temperature Guarded Hot Plate Apparatus

Thermophysical Property Measurement of Thermal Protective Material by Guarded Plane Source Method

Thermal Conductivity Measurement from 30 to 750 K: the 3ω Method

The thermal conductivity measurement for aerogel composite insulation materials by the step-wise transient method in temperature range from 25 to 1200 degrees C

Analysis and experiments of measuring thermal conductivity and diffusivity of materials by plane source-pulse transient method

Effect of Radiative Heat Transfer on Determining Thermal Conductivity of Semi-Transparent Materials Using Transient Plane Source Method

Measurement of the Thermophysical Properties of Anisotropic Insulation Materials with Consideration of the Effect of Thermal Contact Resistance.

Experimental study on measurement accuracy of hot disk thermal constants analyser

Selection of Heating Power in Thermophysical Property Measurement with Transient Hot-strip Method

A high-precision method to measure thermal conductivity of solids using reversible heat flux

A Numerical Study on the Theoretical Accuracy of Film Thermal Conductivity Using Transient Plane Source Method

Experimental Investigation of High Temperature Thermal Contact Resistance of Thin Disk Samples Using Infrared Camera in Vacuum Condition