Abstract:This paper presents a monolithically integrated aptasensor composed of a piezoresistive microcantilever array and an on-chip signal processing circuit. Twelve microcantilevers, each of them embedded with a piezoresistor, form three sensors in a Wheatstone bridge configuration. The on-chip signal processing circuit consists of a multiplexer, a chopper instrumentation amplifier, a low-pass filter, a sigma-delta analog-to-digital converter, and a serial peripheral interface. Both the microcantilever array and the on-chip signal processing circuit were fabricated on the single-crystalline silicon device layer of a silicon-on-insulator (SOI) wafer with partially depleted (PD) CMOS technology followed by three micromachining processes. The integrated microcantilever sensor makes full use of the high gauge factor of single-crystalline silicon to achieve low parasitic, latch-up, and leakage current in the PD-SOI CMOS. A measured deflection sensitivity of 0.98 × 10 − 6 nm −1 and an output voltage fluctuation of less than 1 μV were obtained for the integrated microcantilever. A maximum gain of 134.97 and an input offset current of only 0.623 nA were acquired for the on-chip signal processing circuit. By functionalizing the measurement microcantilevers with a biotin-avidin system method, human IgG, abrin, and staphylococcus enterotoxin B (SEB) were detected at a limit of detection (LOD) of 48 pg/mL. Moreover, multichannel detection of the three integrated microcantilever aptasensors was also verified by detecting SEB. All these experimental results indicate that the design and process of monolithically integrated microcantilevers can meet the requirements of high-sensitivity detection of biomolecules.

Piezoresistive Bridge Microcantilevers Biosensor Based on Soi Wafer for Glucose Detecting

A Glucose Biosensor Based on Piezoresistive Microcantilevers

Simulation and Fabrication of SiO2-based Piezoresistive Microbridges for Chem/biosensors

Modification of microcantilevers using layer-by-layer nanoassembly film for glucose measurement

Glucose Oxidase Multilayer Modified Microcantilevers for Glucose Measurement.

A wireless acoustic wave sensor modified with biocompatible polymer for glucose monitoring

Experimental and theoretical aspects of glucose measurement using a microcantilever modified by enzyme-containing polyacrylamide.

Glucose Biosensor Based on the Microcantilever

A Reflective Mirror Microcantilevers-Based Biosensor for Biochemical Detection

Biochemical Sensors Based on Piezoresistive Microcantilevers

Design of Piezoresistive Micro-Cantilever with Stress Concentration Regions

A MEMS based blood glucose measurement sensor using twin-cantilever structure

High-Sensitivity, Quantified, Linear and Mediator-Free Resonator-Based Microwave Biosensor for Glucose Detection

A Silicon Microcantilever Biosensor Fabricated on SOI Wafers Using a Two-Step Releasing Approach

A Flexible PI/Si/SiO2 Piezoresistive Microcantilever for Trace-Level Detection of Aflatoxin B1

A Monolithically Integrated Microcantilever Biosensor Based on Partially Depleted SOI CMOS Technology

An Enzyme-Metal-Insulator-Silicon Structured Sensor Using Surface Photovoltage Technology for Potentiometric Glucose Detection

A Low Spring Constant Piezoresistive Microcantilever for Biological Reagent Detection

Characterization Of Micromachined Sensors For Nanoscale Detection

Ultrasensitive Detection of Aflatoxin B1 Using a Polyimide-Based Piezoresistive Microcantilever Biosensor