Abstract:The irreversibility of the thermoelectric cooling (TEC) model could analyze and optimize refrigeration performance. In present work, a one-dimensional thermal conductivity model of the internal irreversible thermoelectric element was first established. Subsequently, two categories of evaluation indexes were further analyzed, i.e., cooling capacity Q c and coefficient of performance (COP). The thermodynamic model of TEC was then established jointly with finite time thermodynamics. The influences of current and the ratio of heat transfer areas between cold and hot sides on the steady-state characteristics of TEC were further discussed under Newtonian linear heat transfer. In addition, a transient thermodynamic model of TEC equipment was built to compare the effects of pulse width, pulse gradient, and pulse current on the cold side temperature of the TEC module. Theoretical results demonstrated that the effective working range of the steady-state operating current is 2A ≤ I ≤ 25A, and the area ratio of heat transfer between cold and hot sides is 0.07 ≤ x ≤ 1. The cooling capacity ( Q c ) and coefficient of performance (COP) could reach up to about 50W and 2.0, respectively. In addition, the increase of external heat transfer capacity of the hot side could reduce the transient supercooling temperature and the peak overshoot temperature, simultaneously. Afterward, the cooling capacity was remarkably enhanced. Current research could provide a reliable support for the optimization design and performance improvement of the thermoelectric cooler. Thermal conductivity model of internal irreversible thermoelectric element was established; Effects of cold and hot ends on the TEC were discussed under Newtonian linear heat transfer; Effects of pulse width, gradient and current on TEC cold end temperature were investigated; Heat transfer capacity of TEC hot end could reduce supercooling and overshoot temperatures; The irreversibility of TEC model will enhance its potentials for low grade energy exploitation.

Optimization of heat sink configuration for thermoelectric cooling system based on entropy generation analysis

Optimization of heat sink of thermoelectric cooler using entropy generation analysis

Design Optimization of Thermoelectric Cooling Systems for Applications in Electronic Devices

Evaluating optimal cooling temperature of a single-stage thermoelectric cooler using thermodynamic second law

Analysis on optimal heat exchanger size of thermoelectric cooler for electronic cooling applications

Design and Optimization of Thermoelectric Cooling System under Natural Convection Condition

Irreversibility of thermoelectric cooling model: Newtonian linear heat transfer and finite time thermodynamics

Real-time optimization of thermoelectric coolers' performance based on energy and exergy analysis

A Model to Evaluate the Device-Level Performance of Thermoelectric Cooler with Thomson Effect Considered

Thermodynamic Analysis of TEG-TEC Device Including Influence of Thomson Effect

Multi-parameters Analysis and Optimization of a Typical Thermoelectric Cooler Based on the Dimensional Analysis and Experimental Validation

Modeling of Thermoelectric Generators with Effects of Side Surface Heat Convection and Temperature Dependence of Material Properties

Performance optimization of a class of combined thermoelectric heating devices

Design and optimal coolant flow rate analysis of an annular water-cooled automotive exhaust-based thermoelectric generator

Numerical analysis of thermoelectric power generation coupled with temperature-dependent material properties

Analysis on optimal length scale of thermoelectric generators when using different circuit layouts

Optimization of a Separator Assisted Two-Phase Thermosyphon Loop by Using Entropy Generation Analysis

Optimum allocation of heat transfer surface area for cooling load and COP optimization of a thermoelectric refrigerator

Derivation of generalized thermoelectric energy equations and the study of thermoelectric irreversible processes based on energy, exergy, and entransy analysis

Theoretical Analysis of the Thermoelectric Generator Considering Surface to Surrounding Heat Convection and Contact Resistance

Study on a Dual-Function Thermoelectric Cooler-Thermoelectric Generator System