Abstract:As a promising candidate of rare-earth free hard magnetic materials, L10-FeNi has been paid much attention in the last decades. However, it is difficult to be artificially fabricated due to its low thermal stability and sluggish diffusion ability of atoms below the crucial temperature of 320 °C. In this study, a promising method of annealing amorphous precursor was extensively developed through (Fe50Ni50)84−xSixP16 (x = 0, 4 at%) and (Fe50Ni50)86−xSixP14 (x = 2, 4, 8 at%) alloys. Especially, the effect of Si on the formation of L10 phase in annealed FeNi-based alloys was investigated and clarified. It is found Fe42Ni42P16 with a much low crystallization temperature could be an appropriate basic amorphous alloy for the formation of L10 phase. The addition of Si enhanced the thermal stability of Fe-Ni-P amorphous alloys. Interestingly, Si could stabilize the L10 phase in annealed samples and increase its disordering temperature above which L10-FeNi phase could deteriorate into soft magnetic phase. As expected, appropriate Si addition indeed improved the hard magnetic properties of the annealed alloys and samples with high coercivity above 900 Oe was obtained. Further Si addition would deteriorate the magnetic-crystalline anisotropy of L10 phase and decrease the coercivity of annealed Fe-Ni-Si-P alloys. Nevertheless, the results indicate that increasing the order-disorder transition temperature through element doping in L10 lattice would be a promising strategy for the massive formation of L10-FeNi like other ordered phases (i.e. L12-FeNi, L10-CoPt), and could substantively contribute to the artificial fabrication of FeNi-based rare-earth free magnets in future.

Effects of Au Content on the Structure and Magnetic Properties of L10-FePt Nanoparticles Synthesized by the Sol–gel Method

Effect of Co Addition on the Phase Structure and Magnetic Properties of Fe-Si-Al Alloys

Improvement of magnetic property of L10‐FePt film by FePt∕Au multilayer structure

Influence of Cu on the Improvement of Magnetic Properties and Structure of L10 FePt Nanoparticles

Au composition dependent order-disorder transitions of Fe−Pt intermetallic compounds: experiments and thermodynamic analysis

The role of Cu content on structure and magnetic properties of Fe–Si–B–P–Cu nanocrystalline alloys

Synthesis and Characterization of FePt Nanoparticles and FePt Nanoparticle/sio 2 -Matrix Composite Films

Effects of boron content on the structure and magnetic properties of Fe81-xSi13BxMo2Cr1Cu1P2 nanocrystalline alloys

Large Coercivity FePt Nanoparticles Prepared Via a One-Step Method Without Post-Annealing

Effects of high magnetic field on the growth and magnetic property of L10-FePtCu nanoparticles

Fabrication and magnetic properties of FePt nanoparticle assemblies embedded in MgO-matrix systems

Optimization of Crystallization Behavior and Soft Magnetic Properties of the Si-free Fe-B-P-C-Cu Nanocrystalline Alloys by Cu Content Tuning

Magnetic properties of FePt nanoparticle assemblies embedded in atomic-layer-deposited Al2O3

Improving the ordering and coercivity of L10-FePt nanoparticles by introducing PtAg metastable phase

Preparation and Magnetic Properties of L10–FePt/TiO2 Nanocomposite Thin Films

Fabrication and Magnetic Properties of Fe–Pd Nanowire Arrays

Optimizing Co content in intermetallic L10-FeCoPt nanoparticles to enhance the electrocatalytic performance

Effects of annealing time on structural and magnetic properties of L10-FePt nanoparticles synthesized by the SiO2-nanoreactor method

Effect of Si addition on the magnetic properties of FeNi-based alloys with L10 phase through annealing amorphous precursor

Effect of P addition on soft magnetic properties of Fe–Si–B–P–Cu–C nano-crystalline alloys

Local Structure, Nucleation Sites and Crystallization Behavior and Their Effects on Magnetic Properties of Fe81Si X B10P8−xCu1 (x = 0~8)