Abstract:A novel plasma-driven catalysis (PDC) reactor with special structure was proposed to remove vehicle exhaust gas. The PDC reactor which consisted of three quartz tubes and two copper electrodes was a coaxial dielectric barrier discharge (DBD) reactor. The inner and outer electrodes firmly surrounded the outer surface of the corresponding dielectric barrier layer in a spiral way, respectively. Nano-titanium dioxide (TiO2) film prepared by radiofrequency (RF) magnetron sputtering was coated on the outer wall of the middle quartz tube, separating the catalyst from the high voltage electrode. The spiral electrodes were designed to avoid overheating of microdischarges inside the PDC reactor. Continuous operation tests indicated that stable performance without deterioration of catalytic activity could last for more than 25 h. To verify the effectiveness of the PDC reactor, a non-thermal plasma(NTP) reactor was employed, which has the same structure as the PDC reactor but without the catalyst. The real vehicle exhaust gas was introduced into the PDC reactor and NTP reactor, respectively. After the treatment, compared with the result from NTP, the concentration of HC in the vehicle exhaust gas treated by PDC reactor reduced far more obviously while that of NO decreased only a little. Moreover, this result was explained through optical emission spectrum. The O emission lines can be observed between 870 nm and 960 nm for wavelength in PDC reactor. Together with previous studies, it could be hypothesized that O derived from catalytically O-3 destruction by catalyst might make a significant contribution to the much higher HC removal efficiency by PDC reactor. A series of complex chemical reactions caused by the multi-components mixture in real vehicle exhaust reduced NO removal efficiency. A controllable system with a real-time feedback module for the PDC reactor was proposed to further improve the ability of removing real vehicle exhaust gas.

Regeneration mechanism of Pd/AC catalyst in dielectric barrier discharge plasma

Removal of Dilute VOCs in Air by Post-Plasma Catalysis over Ag-based Composite Oxide Catalysts

Study on Deactivation by Sulfur and Regeneration of Pd/C Catalyst in Hydrogenation of N-(3-nitro-4-methoxyphenyl) Acetamide

Deactivation and Regeneration of Nano-Assembled Pd/C Catalyst for AMA Synthesis

Non-thermal Plasma Generation by Using Back Corona Discharge on Catalyst

Mechanism and Reactive Species in a Fountain-Strip DBD Plasma for Degrading Perfluorooctanoic Acid (PFOA)

Characteristics of Back Corona Discharge in a Honeycomb Catalyst and Its Application for Treatment of Volatile Organic Compounds.

Regeneration Of Nitrobenzene-Exhausted Granular Activated Carbon By Dielectric Barrier Discharge Method

Enhanced Electrocatalytic Dechlorination by Dispersed and Moveable Activated Carbon Supported Palladium Catalyst

Regeneration of Ozone Decomposition Catalysts by Elimination of O2 2 2- from Oxygen Vacancies

Regeneration of Ozone Decomposition Catalysts by Elimination of O22- from Oxygen Vacancies

Optimization for Plasma-facilitated Catalytic Reduction of NO_x

One stone, three birds strategy for synthesis of N-doped activated carbon-supported surface-enriched and redispersed Pd NPs via plasma for formic acid dehydrogenation

Vehicle Exhaust Gas Clearance By Low Temperature Plasma-Driven Nano-Titanium Dioxide Film Prepared By Radiofrequency Magnetron Sputtering

Degradation characteristics of toxic contaminant with modified activated carbons in aqueous pulsed discharge plasma process

Poisoning and Regeneration of Pd Catalyst in Direct Formic Acid Fuel Cell

Dry Reforming of Methane in A Dielectric Barrier Discharge Reactor with Ni/Al2o3 Catalyst: Interaction of Catalyst and Plasma

Electrochemical regeneration of activated carbon loaded with p-nitrophenol in a fluidized electrochemical reactor

Study on the degradation of o-dichlorobenzene by DBD-NTP co-modified titanium gel catalyst

Augmented degradation performance of dielectric barrier discharge plasma via optimized hydroxyl radical generation

Abatement of chlorobenzene by plasma catalysis: Parameters optimization through response surface methodology (RSM), degradation mechanism and PCDD/Fs formation