Abstract:Solvent extraction is an efficient method that separates surfactants and pollutants in pumped groundwater during surfactant-enhanced aquifer remediation (SEAR). This paper addresses the factors that influence the extraction efficiency of solvent extraction method. A series of batch experiments were conducted to verify the effectiveness of solvent extraction by describing the interactions among contaminants, surfactants, and solvents, using factors such as extraction time, solvent/water volumetric ratio, surfactant type and concentration, contaminants type and concentration, solution salinity and solvent equivalent alkyl carbon numbers (EACNs). The surfactants, contaminants, and solvents used were sodium dodecyl sulfate (SDS) and Tween 80, benzene and nitrobenzene, n-hexane, n-decane and n-hexadecane, respectively. The results indicated that (I) the increase in extraction time or solvent/water volumetric ratio caused higher benzene removal efficiency, but the increment of removal was not significant after 2 h or 0.1; (2) surfactant type and concentration significantly affected extraction efficiency. The increase in SDS concentrations could generally increase benzene removal and then decline, whereas benzene removal seldom changed under the studied Tween 80 concentration range. Moreover, Tween 80 losses were much lower than that of SDS. When mixing the two surfactants, benzene was increasingly separated from the aqueous surfactant solutions by increasing the proportion of Tween 80, and surfactant losses almost depended on monomers instead of micelles within the aqueous surfactant solutions; (3) the efficiency of separating benzene from aqueous surfactant solutions was higher than that of nitrobenzene. Furthermore, n-hexane losses in the benzene aqueous solution were higher than that in the nitrobenzene aqueous solution; (4) higher inorganic salt concentration in the aqueous Tween 80 solutions could increase benzene removal and decrease Tween 80 losses, thereby improving extraction efficiency; (5) n-hexane was more suitable to separate benzene from aqueous Tween 80 solutions because its EACN was closest to the EACN of benzene. (C) 2014 Elsevier B.V. All rights reserved.

Extraction performance of bisphenol A from aqueous solutions by emulsion liquid membrane using response surface methodology

Laboratory Evaluation of the Use of Solvent Extraction for Separation of Hydrophobic Organic Contaminants from Surfactant Solutions During Surfactant-Enhanced Aquifer Remediation

Emulsion Liquid Membrane Extraction of Bisphenol A with Three-dimensional Spiral Plate-type Microchannel

Cloud Point Extraction of Bisphenol A from Water Utilizing Cationic Surfactant Aliquat 336

Deep eutectic solvents on extraction of bisphenol A from water matrices: COnductor like Screening MOdel for Real Solvents prediction and experimental validation

Extraction of bromine from brine by emulsion liquid membrane

Ionic Liquid-Based Supported Liquid Membrane Extraction for the Separation of Bisphenol A,Octylphenol and Nonylphenol in Water

Extraction Condition Optimizing Of Poly (3-Hydroxybutyric Acid) From Microorganism Using Response Surface Methodology

The Properties of Surface Active Agents of Microemulsion System (OP-4 + OP-7)/benzylacohol/D2EHPA/cyclohexane/HCl Between Cyclohexane/hcl Aqueous Solution Interface

Removal of Phenol by A New Emulsion Liquid Membrane System and Its Heat-Induced Demulsification

Optimization of Extraction of Phenolic Compounds from Scum Using Response Surface Methodology

Preparation of Polyethersulfone–organophilic Montmorillonite Hybrid Particles for the Removal of Bisphenol A

Investigation of Electrocoagulation Process for Efficient Removal of Bisphenol A from the Aqueous Environment: Promising Treatment Strategy

Degradation of Bisphenol A Enhanced by Dialysis Membrane Enclosed Laccase Catalysis

Study on separation of p-aminobenzoic acid with emulsion liquid membranes

Electro-enhanced solid-phase microextraction with covalent organic framework modified stainless steel fiber for efficient adsorption of bisphenol A

Process optimization of preparation of thin film composite membraneusing response surface methodology

Bisphenol A removal from aqueous solutions using novel UV/persulfate/H2O2/Cu system: optimization and modelling with central composite design and response surface methodology

Catalytic polymerization of bisphenol A using a horseradish peroxidase immobilized microporous membrane reactor

Simultaneous Separation of Multiphase Emulsion Mixture and Catalytic Degradation of BPA Via Microalgae Residue Membranes

Optimization of Ultrasonic-Assisted Extraction of Wedelolactone and Antioxidant Polyphenols from Eclipta Prostrate L Using Response Surface Methodology