The Properties of Surface Active Agents of Microemulsion System (OP-4 + OP-7)/benzylacohol/D2EHPA/cyclohexane/HCl Between Cyclohexane/hcl Aqueous Solution Interface

GONG Fuzhong,MA Peihua,LIU Liheng,TANG Yanxia,HUANG Xiaofeng
DOI: https://doi.org/10.3969/j.issn.1007-8924.2006.05.011
2006-01-01
Abstract:The interfacial tension between cyclohexane solutions contained surfactants such as polyoxy-ethylene (4) nonyl phenol(OP-4), polyoxyethylene(7) nonylphenol(OP-7), benzylalcohol, 2-(2-ethylhexyl-phosphonic) acid (D2EHPA) and HCl aqueous solution were measured by spinning drop method, respectively. On the basis, the Gibbs excesses and molecular cross-section area of these four species at the liquid/liquid interface were calculated using Gibbs adsorption equation. The results showed that the molecular cross-section area of OP-7, OP-4, benzylalcohol, D2EHPA were 55.2×10-20、67.8×10-20、47.3×10-20 and 115.4×10-20 m2, respectively. The CMC values were 8.2×10-4 mol/L for OP-7 and 3.3×10-3 mol/L for OP-4. Their interface activities followed in the order: OP-7OP-4D2EHPAbenzylalcohol. When these four surface active species were mixed together with kerosene and HCl solution, a W/O microemulsion system (OP-4 + OP-7) /benzylalcohol/D2EHPA/kerosene/HCl formed spontaneously which was used as a liquid membrane for neodymium extraction in a WinsorⅡsystem(a bi-phase equilibrium system of W/O microemulsion with excess water or aqueous solution). It indicated that while this microemulsion was dispersed directly in Nd3+ feed solution, the extraction rate was higher above 93 % but no concentrated in the receiving phase. However, while the extraction was altered by the microemulsion within a hollow fiber contactor (HFC), both high extraction rate and enrichment were accomplished.
What problem does this paper attempt to address?