Abstract:Graphene oxide (GO) is a promising material for separations. Nanoscale GO thin films at the air/water interface are excellent experimental models to understand molecular-scale interactions of ions and water with GO. However, the characteristics of GO, such as functional groups and flake size, also affect the thin film properties making it difficult to make systematic studies with GO thin films. This paper reports a simple, reliable, and quick method of preparing ultra-thin GO films, irrespective of their origin, and demonstrates the new opportunities possible with the utilization of this method. The total amount of GO used to form the thin film is significantly less compared to previous examples in the literature, minimizing the dissolved GO in the subphase. X-ray reflectivity (XR) studies show that the majority of the GO film has 1.5 nm thickness over a macroscopic area (~ 100 cm2) with very small roughness. Sum frequency generation (SFG) spectroscopy measurements show that H2O and D2O interact differently with GO films, a property that was not observed before. SFG data show that functional groups vary significantly between different commercially available GO samples. The differences are also characterized with XR at high resolution. X-ray fluorescence near total reflection (XFNTR) measurements show that these differences strongly affect ion adsorption and interfacial water behavior near GO, which are vital properties in separation applications. The results pave the way for future studies to elucidate the complex separation mechanisms with GO.

Self-Assembly of Graphene Oxide on the Surface of Aluminum Foil

Capillary assisted self-assembly and nascent hydrogen reduction of graphene oxide on Al: Formation of C–O–Al bonds under mild condition

Deposition Kinetics Of Graphene Oxide On Charged Self-Assembled Monolayers

Controlled self-assembly of graphene oxide on a remote aluminium foil

Self-assembly of Graphene Oxide at Interfaces.

Self-assembled free-standing graphene oxide fibers

Low Surface Roughness Graphene Oxide Film Reduced with Aluminum Film Deposited by Magnetron Sputtering

Ultrasonication-Assisted Controllable Self-Assembly of Graphene Oxide

Graphene: Self‐Assembly of Graphene Oxide at Interfaces (adv. Mater. 32/2014)

Layer-by-Layer Assembly of Ultrathin Composite Films from Micron-Sized Graphite Oxide Sheets and Polycations

Preparation and Aggregate State Regulation of Co-Assembly Graphene Oxide-Porphyrin Composite Langmuir Films Via Surface-Modified Graphene Oxide Sheets

Acetone-induced graphene oxide film formation at the water-air interface.

Self-Limiting Assembly of Two-Dimensional Domains from Graphene Oxide at the Air/Water Interface

Self-assembly of graphene into three-dimensional structures promoted by natural phenolic acids

Self-Assembled Reduced Graphene Oxide/Polyacrylamide Conductive Composite Films

On the Gelation of Graphene Oxide

Formation Mechanism of 3D Macroporous Graphene Aerogel in Alcohol-Water Media under Gamma-Ray Radiation

Large Area Orientation Films Based On Graphene Oxide Self-Assembly And Low-Temperature Thermal Reduction

Self-assembly, structures, and electrical properties of double-layered GO/α-Fe2O3/GO sandwich films

A Simple Method for Floating Graphene Oxide Films Facilitates Nanoscale Investigations of Ion and Water Adsorption

Preparation and investigation of the microtribological properties of graphene oxide and graphene films via electrostatic layer-by-layer self-assembly