Abstract:The suppression of the coffee-ring effect is important for obtaining uniform colloid deposition. In this study, the controlled deposition of graphene oxide on anodic aluminum oxide (AAO) through the suppression of the coffee-ring effect was investigated. The effect of factors such as the AAO's thickness and pore diameter, the external temperature, and the applied electric potential on downward capillary flow through pores in the presence of outward capillary flow associated with the coffee-ring effect was studied. When graphene oxide (GO) suspension was drop-casted on an AAO substrate, an increasing AAO thickness led to enhanced downward capillary flow, which suppressed the coffee-ring effect. An increase in the pore diameter resulted in greater suppression the coffee-ring effect since GO flakes could not completely block the pore entrance. Furthermore, an elevated temperature suppressed the coffee-ring effect on the AAO substrate through the rapid evaporation of the droplet, which reduced the outward capillary flow. When an electric potential was applied to the droplet, the downward capillary flow improved because of electrowetting and the outward capillary flow was reduced by the Coulomb force. In particular, the effect of the varied electric potential was adjusted by the AAO thickness. These observations indicated that the coffee-ring effect could be suppressed by appropriately setting the outward and downward capillary flows on the AAO substrate. Furthermore, the pore diameter had a stronger influence than the AAO thickness on the drop-casted GO film's thickness. Notably, optimized GO film manipulation and GO film thickness control could be achieved by manipulating the hydrodynamic flow. The findings of this study have the potential to be used in applications such as filtration, gas separation, and wearable sensors, where a uniform thin film is required.

Controlled self-assembly of graphene oxide on a remote aluminium foil

Deposition Kinetics Of Graphene Oxide On Charged Self-Assembled Monolayers

Graphene: Self‐Assembly of Graphene Oxide at Interfaces (adv. Mater. 32/2014)

Self-assembly of Graphene Oxide at Interfaces.

Capillary assisted self-assembly and nascent hydrogen reduction of graphene oxide on Al: Formation of C–O–Al bonds under mild condition

Ultra-fast Self-Assembly and Stabilization of Reactive Nanoparticles in Reduced Graphene Oxide Films

Self-assembled graphene oxide microcapsules with adjustable permeability and yolk-shell superstructures derived from atomized droplets.

Self-Limiting Assembly of Two-Dimensional Domains from Graphene Oxide at the Air/Water Interface

Self-assembled free-standing graphene oxide fibers

Size-controlled Synthesis of Graphene Oxide Sheets on a Large Scale Using Chemical Exfoliation

Annealing a graphene oxide film to produce a free standing high conductive graphene film

Controlled Synthesis of Few-Layered Graphene Sheets on a Large Scale Using Chemical Exfoliation

Driving Forces for the Self-Assembly of Graphene Oxide on Organic Monolayers.

Novel preparation of functionalized graphene oxide for large scale, low cost, and self-cleaning coatings of electronic devices

Enhanced Self–Assembly and Spontaneous Separation for Ultrathin, Air‒Floating Graphene Macrofilms and their Application in Ultrasensitive In‐Site Growth Sensors

Rolling Up Graphene Oxide Sheets Through Solvent-Induced Self-Assembly in Dispersions.

Large-Scale Self-Assembly of anisotropic graphene oxide films via blade Coating: Sustainable design and Stimuli-Responsive performance for biomimicry

Controlled deposition of graphene oxide on an anodic aluminum oxide substrate via coffee-ring effect

Preparation and Aggregate State Regulation of Co-Assembly Graphene Oxide-Porphyrin Composite Langmuir Films Via Surface-Modified Graphene Oxide Sheets

Covalent Synthesis of Organophilic Chemically Functionalized Graphene Sheets

Synthesis of graphene oxide sheets with controlled sizes from sieved graphite flakes