Abstract:Human activities, especially dam construction, have changed the nutrient cycle process at the basin scale. Reservoirs often act as a sink in the basin and more nutrients are retained due to sedimentation, which induces the eutrophication of the surface water system. This paper proposes an integrated methodology to analyze the total nitrogen (TN) accumulation in a drinking water reservoir, based on the soil and water assessment tool (SWAT) model driven by the China Meteorological Assimilation Driving Datasets for the SWAT model (CMADS). The results show that the CMADS could be applied to drive the SWAT model in Northeast China. The dynamic process of TN accumulation indicates that the distribution of TN inputted into the reservoir fluctuated with the dry and wet seasons from 2009–2016, which was mainly governed by the amount of runoff. The annual average TN input and output fluxes of the Biliuhe reservoir were 274.41 × 104 kg and 217.14 × 104 kg, which meant that 19.76% of the TN input accumulated in the reservoir. Higher TN accumulation in the reservoir did not correspond to a higher TN load, due to the influence of flood discharge and the water supply. Interestingly, a higher TN accumulation efficiency was observed in normal hydrological years, because the water source reservoir always stores most of the water input for future multiple uses but rarely discharges surplus water. The non-point sources from fertilizer and atmospheric deposition and soils constituted the highest proportion of the TN input, accounting for 35.15%, 30.15%, and 27.72% of the average input. The DBWD (Dahuofang reservoir to Biliuhe reservoir water diversion) project diverted 32.03 × 104 kg year−1 TN to the Biliuhe reservoir in 2015–2016, accounting for 14.05% of the total annual input. The discharge output and the BDWD (Biliuhe reservoir to Dalian city water diversion) project output accounted for 48.75% and 47.74%, respectively. The effects of inter-basin water diversion projects should be of great concern in drinking water source water system management. There was a rising trend of TN level in the Biliuhe reservoir, which increases the eutrophication risk of the aquatic ecosystem. The TN accumulated in the sediment contributed to a large proportion of the TN accumulated in the reservoir. In addition to decreasing the non-point source nitrogen input from the upper basin, discharging anoxic waters and sediment with a high nitrogen concentration through the bottom hole of the dam could alleviate the nitrogen pollution in the Biliuhe reservoir.

Assessing ways to combat eutrophication in a Chinese drinking water reservoir using SWAT

Evaluating the Effectiveness of the Pollutant Discharge Permit Program in China: A Case Study of the Nenjiang River Basin.

Predicting The Impact Of Management Practices On River Water Quality Using Swat In An Agricultural Watershed

[Water Environmental Capacity Calculation Model for the Rivers in Drinking Water Source Conservation Area].

Critical source areas’ identification for non-point source pollution related to nitrogen and phosphorus in an agricultural watershed based on SWAT model

Simulation Of Hydrology And Nutrient Transport In The Hetao Irrigation District, Inner Mongolia, China

Relating Land Use/Cover and Landscape Pattern to the Water Quality under the Simulation of SWAT in a Reservoir Basin, Southeast China

Water pollution risk simulation and prediction in a drinking water catchment

Water environmental capacity analysis and eutrophication assessment of water-supplied reservoirs

Simulation of Nitrogen and Phosphorus Loads in the Dongjiang River Basin in South China Using SWAT

Simulation of non-point source pollution the Shahe Reservoir catchment in Beijing by using SWAT model

An Integrated Simulation-Monitoring Framework for Nitrogen Assessment: A Case Study in the Baixi Watershed, China

Using the physical-based model swat to evaluate agricultural pollution in the lake erhai watershed, China

Quantifying effects of conservation practices on non-point source pollution in the Miyun Reservoir Watershed, China

An Integrated Methodology to Analyze the Total Nitrogen Accumulation in a Drinking Water Reservoir Based on the SWAT Model Driven by CMADS: A Case Study of the Biliuhe Reservoir in Northeast China

Evaluating the Influence of Hydrological Condition on the Phosphorus Loads in an Agricultural River Basin Using the SWAT Model

Evaluation of non-point source pollution load in Fenhe Irrigation District based on SWAT model

Assessment of nitrogen and phosphorus loads and causal factors from different land use and soil types in the Three Gorges Reservoir Area.

Assessing the Effects of Land Use Changes on Non-Point Source Pollution Reduction for the Three Gorges Watershed Using the Swat Model

Model AVSWAT apropos of simulating non-point source pollution in Taihu lake basin.

Simulation of Spatial and Temporal Distributions of Non-Point Source Pollution Load in the Three Gorges Reservoir Region