Abstract:Amorphous poly(ethylene terephthalate) (PET), which possess a low softening temperature (Ts=75°C), was exploited to fabricate the electrophoresis chip with an integrated gold electrode for amperometric detection, with emphases being focused on the PET surface modification via UV light and air plasma. Both UV irradiation and plasma treatment were found to be able to improve the surface wettability, enhance the supported electroosmotic flow (EOF), and increase thermal bonding strength of PET sheets, with the latter being more efficient and less time-consuming than the former in the surface modification. Upon treated with plasma for 2min, the PET sheets could be thermally bonded at 65°C. T-peer test showed that the bonding strength increased from 10g/cm for native PET sheets to 1250g/cm for the plasma treated sheets when chips were bonded at the softening point, Attenuated-total-internal-reflection spectrum showed that, after being exposed to the UV light, carboxylic groups site-selectively formed in the UV-exposed region on PET surface. These UV-induced carboxylic groups were further utilized as the scaffold for preparation of micro-gold electrode via electroless gold plating. By using this established UV-directed electroless plating and the plasma-assisted thermal bonding techniques, the full PET electrophoresis chip with an integrated micro-gold electrode could be fabricated in common chemistry laboratory without the need of clean rooms. The fabricated PET chips were demonstrated for separation and detection of model analytes of dopamine (DA) and catechol (CA). Satisfactory resolution of the two analytes was achieved within 40s, and detection limits of 0.87μM and 1.28μM for DA and CA were obtained, respectively.

Low-voltage electroosmotic pumping using polyethylene terephthalate track-etched membrane

Low-voltage electroosmotic pumps fabricated from track-etched polymer membranes.

A Performance-enhanced Electroosmotic Pump with Track-etched Polycarbonate Membrane by Allylhydridopolycarbosilane Coating

Fabrication and Performance of a Low Operating Pressure Nanofiltration Poly(vinyl Chloride) Hollow Fiber Membrane

Low‐voltage Efficient Electroosmotic Pumps with Ultrathin Silica Nanoporous Membrane

Study of Pulse Voltage Waveform Enabled Electroosmotic Pump for High Flow Rate and Bubble Free Purpose

A Miniature Low-voltage Bubble-free Electroosmotic Pump with Low Generation of Heat

Ultrafast Selective Ionic Transport Through Heat-Treated Polyethylene Terephthalate Track Membranes with Sub-Nanometer Pores

Electroosmotic Flow of Non-Newtonian Fluid in Porous Polymer Membrane at High Zeta Potentials

Application of a high-pressure electro-osmotic pump using nanometer silica in capillary liquid chromatography.

Modification of Amorphous Poly(ethylene Terephthalate) Surface by UV Light and Plasma for Fabrication of an Electrophoresis Chip with an Integrated Gold Microelectrode

Melt polymer drawn single and multi-capillary fibre-based electroosmotic pumps

ac electroosmotic pumping induced by noncontact external electrodes

Characterization of the Surface Charge Property and Porosity of Track-etched Polymer Membranes

Electroosmotic flow in poly(dimethylsiloxane) microchannels.

A Mobile and Self‐Powered Micro‐Flow Pump Based on Triboelectricity Driven Electroosmosis

Electrokinetic control of fluid in plastified laser-printed poly(ethylene terephthalate)-toner microchips

A Bubble-free Electroosmotic Pump with Polyaniline-wrapped Platinum-coated Titanium Mesh Electrodes

Effect of external electric fields on the ionic conductivity of the PET ion-track membrane

On-chip pressure generation using a gel membrane fabricated outside of the microfluidic network

Electroosmotic flow: From microfluidics to nanofluidics