Abstract:Since 1990, many groups of pressure–volume–temperature (PVT) data from experiments and molecular dynamics (MD) or Monte Carlo (MC) simulations have been reported for supercritical and subcritical water. In this work, fifteen groups of PVT data (253.15–4356 K and 0–90.5 GPa) are evaluated in detail with the aid of the highly accurate IAPWS-95 formulation. The evaluation gives the following results: (1) Six datasets are found to be of good accuracy. They include the simulated results based on SPCE potential above 100 MPa and those derived from sound velocity measurements, but the simulated results below 100 MPa have large uncertainties. (2) The data from measurements with a piston cylinder apparatus and simulations with an exp-6 potential contain large uncertainties and systematic deviations. (3) The other seven datasets show obvious systematic deviations. They include those from experiments with synthesized fluid inclusion techniques (three groups), measured velocities of sound (one group), and automated high-pressure dilatometer (one group) and simulations with TIP4P potential (two groups), where the simulated data based on TIP4P potential below 200 MPa have large uncertainties. (4) The simulated data but those below 1 GPa agree with each other within 2–3%, and mostly within 2%. The data from fluid inclusions show similar systematic deviations, which are less than 2–5%. The data obtained with automated high-pressure dilatometer and those derived from sound velocity measurements agree with each other within 0.3–0.6% in most cases, except for those above 10 GPa. In principle, the systematic deviations mentioned above, except for those of the simulated data below 1 GPa, can be largely eliminated or significantly reduced by appropriate corrections, and then the accuracy of the relevant data can be improved significantly. These are very important for the improvement of experiments or simulations and the refinement and correct use of the PVT data in developing thermodynamic models of water or water-bearing fluids.

Viscosity of water in the region around the critical point

Evaluation of the Pressure–volume–temperature ( PVT ) Data of Water from Experiments and Molecular Simulations Since 1990

A Online Capillary Method for Viscosity Measurement under High Temperature and Pressure

Temperature Dependence of the Contact Angle of Water on a Hydrophobic Surface at Pressurized Condition

Thermodynamic properties calculation method for moist air: 173 to 647 K

Measurement of Isobaric Heat Capacity of Pure Water Up to Supercritical Conditions

In Situ Brillouin Scattering Study of Water in High Pressure and High Temperature Conditions

Extension of the IAPWS-95 formulation and an improved calculation approach for saturated properties

Thermodynamics of pure liquid water: Sound speed measurements to 700 MPa down to the freezing point, and an equation of state to 2300 MPa from 240 to 500 K

High Pressure-Temperature Brillouin Study of Liquid Water: Evidence of the Structural Transition from Low-Density Water to High-Density Water

Accurate curve fits of IAPWS data for high-pressure, high-temperature single-phase liquid water based on the stiffened gas equation of state

Viscosity Measurements of the H-2-CO2, H-2-CO2-CH4, and H-2-H2O Mixtures and the H-2-CO2-CH4-CO-H2O System at 280-924 K and 0.7-33.1 MPa with a Capillary Apparatus

Correlation for Viscosities of Pure Liquids at High Pressures

A New Three-Parameter Viscosity-Temperature Equation for Saturated Liquids from the Triple Point to the Critical Point

A New Method for Liquid Viscosity Measurements: Inclined-Tube Viscometry

Thermophysical properties of the SPC/E model of water between 250 and 400 K at pressures up to 1000 MPa

Viscosity and Stokes-Einstein relation in deeply supercooled water under pressure

Experimental Measurement Of Jp-10 Viscosity At 242.7-753.3 K Under Pressures Up To 6.00 Mpa

Viscosity Measurements of N-Dodecane at Temperatures Between 303 K and 693 K and Pressures Up to 10 MPa

X-ray Raman Scattering of Water Near the Critical Point: Comparison of an Isotherm and Isochore

Efficient and Accurate Computation Scheme of P–t Thermodynamic Properties of Water and Steam