Abstract:Since 1990, many groups of pressure–volume–temperature (PVT) data from experiments and molecular dynamics (MD) or Monte Carlo (MC) simulations have been reported for supercritical and subcritical water. In this work, fifteen groups of PVT data (253.15–4356 K and 0–90.5 GPa) are evaluated in detail with the aid of the highly accurate IAPWS-95 formulation. The evaluation gives the following results: (1) Six datasets are found to be of good accuracy. They include the simulated results based on SPCE potential above 100 MPa and those derived from sound velocity measurements, but the simulated results below 100 MPa have large uncertainties. (2) The data from measurements with a piston cylinder apparatus and simulations with an exp-6 potential contain large uncertainties and systematic deviations. (3) The other seven datasets show obvious systematic deviations. They include those from experiments with synthesized fluid inclusion techniques (three groups), measured velocities of sound (one group), and automated high-pressure dilatometer (one group) and simulations with TIP4P potential (two groups), where the simulated data based on TIP4P potential below 200 MPa have large uncertainties. (4) The simulated data but those below 1 GPa agree with each other within 2–3%, and mostly within 2%. The data from fluid inclusions show similar systematic deviations, which are less than 2–5%. The data obtained with automated high-pressure dilatometer and those derived from sound velocity measurements agree with each other within 0.3–0.6% in most cases, except for those above 10 GPa. In principle, the systematic deviations mentioned above, except for those of the simulated data below 1 GPa, can be largely eliminated or significantly reduced by appropriate corrections, and then the accuracy of the relevant data can be improved significantly. These are very important for the improvement of experiments or simulations and the refinement and correct use of the PVT data in developing thermodynamic models of water or water-bearing fluids.

Accurate curve fits of IAPWS data for high-pressure, high-temperature single-phase liquid water based on the stiffened gas equation of state

Development of Martin-Hou Equation of State for Water

A Modified Patel-Teja Equation of State for Cryogenic Fluids*

Evaluation of the Pressure–volume–temperature ( PVT ) Data of Water from Experiments and Molecular Simulations Since 1990

Thermodynamic properties calculation method for moist air: 173 to 647 K

Extension of the IAPWS-95 formulation and an improved calculation approach for saturated properties

Efficient and Accurate Computation Scheme of P–t Thermodynamic Properties of Water and Steam

Thermodynamics of pure liquid water: Sound speed measurements to 700 MPa down to the freezing point, and an equation of state to 2300 MPa from 240 to 500 K

High Pressure-Temperature Brillouin Study of Liquid Water: Evidence of the Structural Transition from Low-Density Water to High-Density Water

In Situ Brillouin Scattering Study of Water in High Pressure and High Temperature Conditions

Rapid Calculation for Density of Water and Steam on P-T Thermodynamic Surface

Water at Positive and Negative Pressures

Data-Driven Modeling of General Fluid Density Under Subcritical and Supercritical Conditions

Viscosity of water in the region around the critical point

Appropriate Formulations for Velocity and Pressure Calculations at Gas-liquid Interface with Collocated Variable Arrangement

Examination of Appropriate Formulations for Velocity and Pressure Calculation Methods at Interfacial Region on Collocated Physical Variables' Distribution

The Evolution of Multicomponent Systems at High Pressures: II. The Alder-Wainwright, High-Density, Gas-Solid Phase Transition of the Hard-Sphere Fluid

Efficient Evaluation of Thermodynamic Properties of Water and Steam on P–h Surface

An Equation of State For The TIP4P/2005 Model of Water Including Negative Pressures

AQUA: A Collection of H$_2$O Equations of State for Planetary Models

Measurement of Isobaric Heat Capacity of Pure Water Up to Supercritical Conditions