Quantification of paclitaxel in rat plasma by LC-MS/MS and pharmacokinetics of paclitaxel thermosensi-tive liposomes in rats

Dong Xu,Wei Gong,Nan Liu,YU Fang-lin,MEI Xing-guo,HU Fu-qiang
2012-01-01
Abstract:OBJECTIVE: To develop and validate a liquid chromatography-tandem mass spectrometry (LC-MS/MS) method for the quantification of paclitaxel in rat plasma and to study the pharmacokinetics of paclitaxel thermosensitive liposomes in rats. METHODS: The plasma was alkalized with sodium bicarbonate (pH 8.0) and extracted with tert-butyl methyl ether (TBME). Paclitaxel and IS(docetaxel) were separated on an Agilent Zorbax SB C18 column (2.1 mm × 50 mm, 3.5 μm) with the mobile phase consisting of methanol-0.5 mmol · L-1 ammonium acetate (70: 30, V/V) at a flow rate of 300 μL · min-1. The injection volume was 5 μL An Agilent 6410 A QQQ triple-quadrople mass spectrometer equipped with an electrospray ionization (ESI) source was used as detector and was operated in positive ion mode. Selected ion monitoring (SIM) was performed and the m/z of ions selected for quantitation were 876.3 → 308.1 (paclitaxel) and 830.2 → 549.2 (internal standard, docetaxel) . SD rats were injected paclitaxel thermosensitive liposomes and paclitaxel injection via tail vein at the dose of 7 mg · kg-1, respectively. Pharmacokinetic parameters were calculated. RESULTS: The chromatograms showed no endogenous interfering peaks in blank rat plasma. Each analysis was completed within 3.5 min. The linear range of paclitaxel in plasma was 2-1 000 ng · mL-1. The lower limit of quantification was 2 ng · mL-1. The intra-run and inter-run relative standard deviations (RSDs) were less than 15%. The differences of f1/2β, MRT, AUC and CL were significant between the two preparations. CONCLUSION: The method is sensitive, accurate, and convenient for the pharmacokinetic study of paclitaxel thermosensitive liposomes. Compared with paclitaxel injection, paclitaxel thermosensitive liposomes has a controlled release rate, which can alleviate the acute toxicity and improve the tolerance to a certain extent.
What problem does this paper attempt to address?