Highly Conductive Copper–Silver Bimodal Paste for Low-Cost Printed Electronics
Amin Zareei,Sarath Gopalakrishnan,Zeynep Mutlu,Zihao He,Samuel Peana,Haiyan Wang,Rahim Rahimi
DOI: https://doi.org/10.1021/acsaelm.1c00345
IF: 4.494
2021-08-13
ACS Applied Electronic Materials
Abstract:Printed electronics are circuits that are additively manufactured using conductive pastes composed of micro-/nanoconductive metal particles. Silver-based compounds are the most widely used metals for such pastes due to their superior conductivity and oxidation stability. However, the high cost of silver (Ag) has demanded its replacement with more cost-effective and abundant metals such as copper (Cu). Despite its cost-effectiveness and abundance, Cu suffers from high oxidation tendency and sintering temperature that have limited its widespread utilization in printed electronics. In this work, we have developed a low-cost hybrid bimodal paste composed of Cu microparticles (1–5 μm) and Ag nanoparticles (20–30 nm) (CuMPs/AgNPs) via nondestructive photonic sintering. The concurrent melting of AgNPs and catalytic reduction of CuMPs allow the paste to be sintered at considerably low temperatures using an intense-pulsed light (IPL) source. The required light energy density for effective sintering of different mixing ratios of AgNPs and CuMPs was systematically measured using electrical, optical, and mechanical characterization techniques. These analyses revealed that a minimum of 16 wt % AgNPs in the bimodal CuMP/AgNP paste with an IPL irradiation energy of 10.6 J/cm2 and pulse duration of 5 ms achieved a minimum sheet resistance of 0.072 Ω/□ that results from localized melting of AgNPs between adjacent CuMPs. Furthermore, the CuMP/AgNP films with a minimum of 6 wt % AgNPs showed significantly improved oxidation stability characteristics even after 7 days of incubation in accelerated oxidation conditions [70 °C and 100% relative humidity (RH)]. As a proof of concept, we demonstrated an application of the developed paste (CuMPs-6 wt % AgNPs) by directly printing a wireless resonant moisture sensor onto the interior region of a cardboard package box, which is capable of performing in situ monitoring of the moisture ranging from 30 to 85% RH with an average linear sensitivity of −3.08 % RH/MHz.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsaelm.1c00345.Thermal behavior of PVP, effect of drying temperature and duration on sheet resistance of the oven-dried CuMPs-6 wt % AgNP printed trace, followed by photonic sintering with optimum setting of two pulses at 10.6 J/cm2 energy, effect of EG on sheet resistance of the paste with CuMPs-6 wt % AgNP and CuMPs-16 wt % AgNP compositions, reoxidation, and damage assessment of the hybrid bimodal paste after photonic sintering with excessive thermal energy, effect of increasing thermal energy on sheet resistance of CuMPs-0 wt % AgNP printed trace EDX spectrum and elemental composition analysis (at %) of the photonically sintered CuMPs-16 wt % AgNP printed trace with optimum settings, and 3D confocal microscopy analysis of CuMPs-20 wt % AgNP printed trace (PDF)This article has not yet been cited by other publications.
materials science, multidisciplinary,engineering, electrical & electronic