Abstract:Titania-based nanocomposites have recently attracted much attention due to their unique structure and properties. Titania has been known to have three crystal phases: brookite, anatase and rutile. The anatase titania has the highest photoactivity than the other two phases. Meanwhile Ohtani et al. [1] reported that amorphous titania has a negligible photoactivity compared to the crystalline titania. Much work has been conducted on the optimization of catalytic properties of titania used in the photodegradation of organic pollutants in water by either using modified titania or thin titania films. Many researches indicated that dopants, such as many oxides, can effectively suppress the transformation of anatase into rutile by improving the onset transformation temperature [2]. Silica-titania mixed oxide is considered a potential candidate because it is used as not only a good photocatalyst itself but also a support material for other chemical reaction catalysts [3, 4]. 30SiO2/TiO2 powders (30 denotes the weight percent of silica) were prepared by sol-gel process. Ti(OBu n )4 and TEOS were used as precursors of titania and silica respectively. After TEOS was stirred in a mixture solution of pure ethanol, distilled water and hydrochloric acid for 1 h, Ti(OBu n )4 was added slowly into the mixture. The sol of SiO2/TiO2 was obtained after another two hours’ vigorous stirring and cooled to room temperature. The gel was calcined at different temperatures and then ground into fine powders. The distilled water solution of methyl orange (with a concentration of 25 mg/L) was chosen for photodegradation. 0.2 g powders were added into 40 ml of the above solution with vigorous agitation under the mercury light. A 756MC UV-VIS spectrometer was used to record the change of concentration of the methyl orange. FT-IR spectra was obtained by a Bruker EQUINOX55 spectrometer. TEM and HREM observations were carried out using a Jeol-2010 electron microscope. The XRD patterns were made in a D/max3A diffractometer with Cu Kα radiation. The crystallite size of powders was determined by Scherrer equation. Electron spin resonance measurements were made with a Bruker paramagnetic spectrometer. X-ray photoelectron spectroscopy (XPS) spectra of the sample were obtained with an NP-1 using the Mg Kα excitation source and the binding energies referenced to the C1s hydrocarbon line at 284.6 eV. The atomic ratios were obtained by intergrating the areas under the peak. Photodegradation for methyl orange with 30SiO2/ TiO2 samples calcinated at different temperature under UV irradiation is illustrated in Fig. 1. The results of other samples heated at temperatures higher than 850 ◦ C were not shown in this figure because further increase of the calcination temperature decreased the decomposition rate. It can be seen that decomposition rate of the samples fired at 400 ◦ C and 500 ◦ Ci s low. When the calcination temperature was further increased to 600 ◦ C, the higher photoactivity than Degussa P25’s was obtained. The sample heated at 800 ◦ C has the best photoactivity about 2 times higher than the Degussa P25.

Preparation of flexible BOPP/SiO x/TiO 2 multilayer film for photodegradation of organic contamination

Preparation of TiO_2/SiO_2 and Photo-Catalytic Degradation of Methyl-Orange

TiO2 Nanoparticles Supported on PMMA Nanofibers for Photocatalytic Degradation of Methyl Orange

Ag/Co/B Tri-Doped TiO2/SiO2 Film for Enhancing Photocatalytic Degradation

Photoelectrocatalytic Processes of TiO2 Film: The Dominating Factors for the Degradation of Methyl Orange and the Understanding of Mechanism

A P/N type compounded Cu 2 O/TiO 2 photo-catalytic membrane for organic pollutant degradation

Enhanced photoactivity of silica-titania binary oxides prepared by sol-gel method

Enhanced Photocatalytic Degradation of Perfluorooctanoic Acid by Mesoporous Sb2O3/TiO2 Heterojunctions

Hydrophobic Modification of Bi2O3-Doped Si-Ti Composite Film on a Wood Surface

Antibacterial photocatalytic films for effective degradation of organic compounds

Efficient visible light induced degradation of organic contaminants by Bi2WO6 film on SiO2 modified reticular substrate

Hydrophobicity and Photocatalytic Activity of a Wood Surface Coated with a Fe3+-Doped SiO₂/TiO₂ Film

Fabrication of TiO2-containing Nanocomposite Films and Their Photocatalytic Degradation for Methyl Orange

Preparation of a Self-Cleaning TiO2-SiO2/PFDTS Coating with Superamphiphobicity and Photocatalytic Performance

Fabrication and Photocatalytic Properties of Porous Crystalline Titanium Dioxide Film Co-Doped with Fe and Si by PEO

Facile Fabrication of Mesoporous SiO2@(cTiO2/BiOI) Heterojunctions with Enhanced Photocatalytic Properties Due to Large Surface Area for Contact with Pollutants

Fabrication of hydroxyl group modified monodispersed hybrid silica particles and the h-SiO2/TiO2 core/shell microspheres as high performance photocatalyst for dye degradation

The Preparation of TiO2 Film by the Sol-Gel Method and Evaluation of Its Self-Cleaning Property

Preparation of TiO2–SiO2 film with high photocatalytic activity on PET substrate

Facile Fabrication of Mesoporous SiO2@(cTiO2/BiOI) 2 @(ctio 2 /bioi) Heterojunctions with Enhanced Photocatalytic Properties Due to Large Surface Area for Contact with Pollutants

TiO2/SiO2 Composite Films Immobilized on Foam Nickel Substrate for the Photocatalytic Degradation of Gaseous Acetaldehyde