Abstract:Sulfur hexafluoride (SF6) gas, widely used in high-voltage circuit breakers, has a high global warming potential and hence substitutes are being sought. The use of a mixture of carbon tetrafluoride (CF4) and SF6 is examined here. It is known that this reduces the breakdown voltage at room temperature. However, the electrical breakdown in a circuit breaker after arc interruption occurs in a hot gas environment, with a complicated species composition because of the occurrence of dissociation and other reactions. The likelihood of breakdown depends on the electron interactions with all these species. The critical reduced electric field strength (the field at which breakdown can occur, relative to the number density) of hot SF6/CF4 mixtures corresponding to the dielectric recovery phase of a high voltage circuit breaker is calculated in the temperature range from 300K to 3500 K. The equilibrium compositions of hot SF6/CF4 mixtures under different mixing fractions were determined based on Gibbs free energy minimization. Full sets of improved cross sections for interactions between electrons and the species present are presented. The critical reduced electric field strength of these mixtures was obtained by balancing electron generation and loss mechanisms. These were evaluated using the electron energy distribution function derived from the Boltzmann transport equation under the two-term approximation. The result indicates that critical electric field strength decreases with increasing heavy-particle temperature from 1500 to 3500 K. Good agreement was found between calculations for pure hot SF6 and pure hot CF4 and experimental results and previous calculations. The addition of CF4 to SF6 was found to increase the critical reduced electric field strength for temperatures above 1500 K, indicating the potential of replacing SF6 by SF6/CF4 mixtures in high-voltage circuit breakers. (C) 2013 AIP Publishing LLC.

Dielectric Breakdown Properties of SF6–N2 Mixtures in the Temperature Range 300–3000 K

Dielectric Breakdown Properties of SF6–N2 Mixtures at 0.01–1.6 MPa and 300–3000 K

Investigation of dielectric breakdown properties of sf 6 – n 2 and sf 6 – cf 4 mixtures at 0 . 4 mpa and gas temperatures up to 3000

Study of the Dielectric Breakdown Properties of Hot SF6–CF4 Mixtures at 0.01–1.6 MPa

Study of Dielectric Breakdown Properties in 50%SF6-50%CF4 Mixtures at 1 Atm

Breakdown Electric Field Calculation of Hot SF6 and Its Application to High Voltage Circuit Breakers

Dielectric Breakdown Properties of Hot SF6-CO2 Mixtures at Temperatures of 300–3500 K and Pressures of 0.01–1.0 MPa

Dielectric breakdown properties of hot SF{sub 6}-CO{sub 2} mixtures at temperatures of 300–3500 K and pressures of 0.01–1.0 MPa

Influence of PTFE Vapor on Dielectric Breakdown Property of Hot SF6 Gas

Investigation on the Dielectric Properties of Hot CO2 and CO2-based Gas Mixtures Based on the Boltzmann Equation Analysis

Investigation on the Reduced Critical Breakdown Field of Hot CO2 Gas and CO2-based Mixtures

Analysis of the Dielectric Breakdown Characteristics for a 252-Kv Gas Circuit Breaker

Dielectric Breakdown Properties of N2–O2 Mixtures by Considering Electron Detachments from Negative Ions

Study on N2–SF6 Mixtures Breakdown Characteristics at the Gas/dielectric Interface of Microwave Window

Analysis of Insulation Characteristics of SF6/N2 Gas Mixtures with Monte Carlo Method

Investigation of Dielectric Properties of Cold C3F8 Mixtures and Hot C3F8 Gas As Substitutes for SF6

Dielectric Properties of Fluoronitriles/co 2 and SF 6 /N 2 Mixtures As a Possible SF 6 -Substitute Gas

Dielectric Breakdown Properties of Hot SF6gas Contaminated by Copper at Temperatures of 300–3500 K

Calculation of the Insulation Properties of Different CF3I-N2 and CF3I-CO2 Mixtures at 300 K

Investigation on Critical Breakdown Electric Field of Hot Sulfur Hexafluoride/Carbon Tetrafluoride Mixtures for High Voltage Circuit Breaker Applications

Dielectric Breakdown Properties of Hot Sf6/He Mixtures Predicted from Basic Data