Abstract:The development of a realistic numerical model that predicts the impact behavior of adhesively bonded composite joints is important for many industrial sectors such as automotive, aerospace, and marine. In this study, it was aimed to develop a numerical model that can predict the low-velocity oblique impact behavior of composite single-lap joints close to the experimental results. The validation of the proposed numerical model was carried out with the results of the previously experimentally tested joints. In explicit finite element analysis, the orthotropic material model and Hashin's damage criterion were used in the numerical model of composite adherends. The adhesive region was divided into three different regions. The cohesive zone model (CZM) was used to determine the damage initiation and propagation in the upper and lower interface regions of adhesive. The middle region of the adhesive between the two cohesive interfaces was modeled with an elastic–plastic material model to reflect the plastic material behavior of the adhesive in the analysis. The effects of impact angle, fiber orientation, and overlap length on adhesive damage initiation and propagation were investigated in detail. There is a good agreement between the numerical and experimental results, considering the contact force-time variations and composite and adhesive damage. The impact angle and fiber angle had a significant effect on the impact behavior of the composite joints and the adhesive damage initiation and propagation. The increase in impact angle and fiber angle caused a decrease in the maximum contact force value. Adhesive damage propagation patterns varied according to the composite fiber orientation. In addition, since the shear toughness of the adhesive is higher than its tensile toughness, the amount of adhesive damage and damage propagation rate decreased as the impact angle increased.

Modeling of High Strength Steel Joints Bonded with Toughened Adhesive for Vehicle Crash Simulations

Modelling of Deformation and Failure of Crash Toughened Adhesive Bonded Lap Shear Joints

Evaluation of the cracked lap shear test for mixed-mode fracture toughness estimation of adhesive joints

A Length-Free Phase Field Model for Epoxy Adhesive Materials Based on Modified Drucker–Prager Criterion

Viscoelastic Bilinear Cohesive Model and Parameter Identification for Failure Analysis of Adhesive Composite Joints

Modeling the Interfacial De-Bonding Behavior Between Steel Wire and Adhesive

Development of A High-Efficiency Modeling Technique for Weld-Bonded Steel Joints in Vehicle Structures, Part Ii: Dynamic Experiments and Simulations

Dynamic Characteristics of Adhesive Bonded High Strength Steel Joints

Influence of Failure-Load Prediction in Composite Single-Lap Joints with Brittle and Ductile Adhesives Using Different Progressive-Damage Techniques

Computational modelling of postbuckling behavior of composite T-stiffened panels with different bonding methods

Experimental study of strain rate effects on the strength of adhesively bonded joints after hygrothermal exposure

Effect of Base Steels on Mechanical Behavior of Adhesive Joints with Dissimilar Steel Substrates

Finite Element Analysis of Low-Speed Oblique Impact Behavior of Adhesively Bonded Composite Single-Lap Joints

Determination of fracture toughness of an adhesive in civil engineering and interfacial damage analysis of carbon fiber reinforced polymer–steel structure bonded joints

Finite Element Analysis of Adhesive Failure of Solid Composite Propellant Multi-material Structure for Underwater Intelligent Equipment

Computational Fracture Mechanics Assessment of Adhesive Joints

Characterization and material model definition of toughened adhesives for finite element analysis

Modeling of the tubular shell of laminated connector materials during impact loading

Investigation of Residual Strength in CFRP Double-Adhesive Single Lap Bonded Joints after Low-velocity Impact

Effectiveness analysis of the study on the bonding performance of car soft decoration coated interior trim based on cohesive zone model

Studies on a computational model and the stress field characteristics of weld-bonded joints for a car body steel sheet