Abstract:A cost-effective approach to manufacture Carbon/Carbon composites is to infiltrate carbon fiber preforms with a polymer precursor and pyrolyze it to form the carbon matrix. During pyrolysis, the microstructure changes due to decomposition reactions creating a high degree of porosity consisting of interconnected network of voids and cracks. To densify, the pyrolyzed composite is infiltrated with polymer precursor to fill the porous network. The cycle of pyrolysis followed by infiltration is repeated until the porosity is minimized and the desired density is achieved. The permeability, porosity and viscosity of the polymer govern the infusion pressure and time for the re-infiltration steps. In this work, the permeability of benzoxazine-based Carbon/Carbon composites was measured for different degradation levels with three distinctly different pyrolyzing schedules. The samples were characterized systematically at increasing pyrolyzing temperatures until full conversion of the precursor into carbon matrix was achieved. The porosity of the material was evaluated by X-ray micro-computed tomography and by pycnometry. The through the thickness permeability of the composite was measured via a pulse-decay experiment after each heating step in the pyrolysis cycle. In this experiment pressure decay with time is recorded as air is evacuated from the cavity through the connected pathways of the porous network within the sample. The experimental correlation between the permeability and interconnected porosity of the microstructure is established. It is shown that the pulse-decay test with air effectively characterizes the permeability of the pyrolyzed composite.

Influence of Infiltration Pressure on the Densification Rate and Microstructure of Pyrocarbon During Chemical Vapor Infiltration

Correlation of the permeability and porosity development of carbon/carbon composites during pyrolysis

Chemical Supercritical Fluid Infiltration of Pyrocarbon with Thermal Gradients: Deposition Kinetics and Multiphysics Modeling

Effect of chemical vapor infiltration on the flexural properties of C/C-SiC composites prepared by the precursor infiltration pyrolysis method

Effect of Chemical Vapor Deposition Pressure on Preferred Orientation, Microstructure, and Oxidation Resistance of Pyrolytic Graphite

Influence of pyrolysis pressure on structure and combustion reactivity of Zhundong demineralized coal char

Effects of Pressurized Pyrolysis on the Chemical and Porous Structure Evolution of Coal Core during Deep Underground Coal Gasification

Effects of Pressure on the Characteristics of Bituminous Coal Pyrolysis Char Formed in a Pressurized Drop Tube Furnace

The effect of carbon nanotubes on the microstructure and morphology of pyrolytic carbon matrices of C–C composites obtained by CVI

Effects of CO2 on Gas Evolution and Char Structure Formation During Lump Coal Pyrolysis at Elevated Pressures

Pressure Effects on Morphology of Isotropic Char Layer, Shrinkage, Cracking and Reduced Heat Transfer of Wooden Material

Mechanical and thermal conduction properties of carbon/carbon composites with different carbon matrix microstructures

PyC interphase growth mechanism and control models of C/SiC composites

Effects of Heat Treatment on Microstructure and Mechanical Properties of 2.5D Cf/BN/pyrocarbon Composites by Chemical Vapor Infiltration

Microstructure and mechanical properties of 3D Cf/SiBCN composites fabricated by polymer infiltration and pyrolysis

Investigation on Structure and Reactivity of Demineralized Coal under Pressurized O 2/H 2O Conditions

GROWTH CHARACTERS AND MODEL OF PYROLYTIC CARBON IN CHEMICAL VAPOR INFILTRATION PROCESS

Study on the Formation and Dissipation Mechanism of Gas Phase Products During Rapid Pyrolysis of Superfine Pulverized Coal in Entrained Flow Reactor

Effects of Carbonization Pressure on Microstructure of Graphitized Pitch-derived Carbons

Microstructure of the pyrocarbon in aligned carbon nanotube/carbon composites

PYROLYSIS STUDIES ON COAL MACERALS USING DTA-GC,13C-NMR AND SEM TECHNIQUES