Abstract:Improving the physical and mechanical properties such as hardness and strength of metal thin films can be achieved by incorporating nanoparticles into the pure metals, for example via electrocodeposition. However, the agglomeration of nanoparticles during electrocodeposition of nanocomposite thin films is an unresolved issue. This paper presents the preliminary results of electrocodeposition thin nanocomposite films under different processing conditions. The microstructure and distribution of Al2O3 nanoparticles in electrocodeposited Cu matrix nanocomposite thin films on a pure Al plate were examined. In addition, the effect of electrolyte concentration on the agglomeration of nanoparticles was studied. Different stirring times were used for electrodepositing the alumina/Cu nanocomposite and the pure Cu control film. Under the constant stirring condition, different deposition times including 1, 4, 8, 12, and 24 hours were taken to study the differences between the agglomeration states of the alumina nanoparticles with the time change. We also examined the effect of turning the electromagnetic stirrer ON and OFF at different time intervals from as short as every 20 minutes to as long as ON and OFF every 2 hours on the nanoparticle agglomeration in the film Optical and electron microscopic studies were made to reveal the microstructure of the nanocomposite. It is found that there is no significant difference in microstructures for the specimens that made under either intermittent stirring or constant stirring for the same length of time.

A Novel Method for the Preparation of Cu/Al2O3 Nanocomposite

Nanostructured Composite Obtained by Mechanically Driven Reduction Reaction of Cuo and Al Powder Mixture

A Simple and Novel Method for Large-Scale Preparation of Stable Copper Nanoparticles

Preparation of NiAl2O4/Al2O3 composite nanopowder

Nanoparticle Reinforced Metal Composites Prepared by Electrocodeposition

Reduction reaction in Al-CuO powder mixture driven by mechanical alloying

Preparation of Ag-Al2O3 nano-composites powder

Preparation and microstructure of nano-sized Cu particles by mechanochemical reaction

Novel synthesis of CuW composite reinforced with lamellar precipitates via aluminothermic reduction

Probing on Mutual Interaction Mechanisms of the Ingredients of Al/CuO/PVDF Nanocomposites

PREPARATION OF Cu MATRIX COMPOSITE REINFORCED WITH IN-SITU NANOSIZED Al2O3 PARTICLE POWDER FROM METAL NITRATES

Fabrication and characterization of Al–CuO nanocomposites prepared by sol-gel method

Preparation of highly photocatalytic active nano-size TiO2–Cu2O particle composites with a novel electrochemical method

Preparation and optical properties of Cu2O hollow microsphere film and hollow nanosphere powder via a simple liquid reduction approach

Fabricating Nanometer Cu/Al Composite Powder by Electroless Copper Plating

The Preparation and Catalytic Performance of Nanoporous CuO/CeO<sub>2</sub> Composites

A Novel Two-Step Processing Method for Fabrication of in Situ Al2O3np/Al-Al11Ce3 Nanocomposite

Preparation & characterization of composite with micron AI coating in nanometer Fe particles

The Preparation and Catalytic Performance of Nanoporous CuO/CeO 2 Composites

Preparation of Fe_2O_3/Al Nanocomposite by Sol-gel Method

Preparation of Wcu Composite Powders by Sol-Gel Method and Their Reduction Behavior