Abstract:SO3 in coal-fired flue gas will cause equipment corrosion and the emission of sulfuric acid mist. The performance of injecting the alkaline adsorbent into the flue gas to remove SO3 is affected by the adsorption of SO2 in the flue gas. Taking Ca(OH)(2) as a typical alkaline adsorbent, a model describing the adsorption of SO3 and SO2 by Ca(OH)(2) particles was established, based on the combination of the product island-growth model and the grain model. The parameters in the model were determined by the experimental data of adsorption in the fixed-bed reactor. The adsorption process of a single Ca(OH)(2) particle was studied by numerical simulation. The adsorption of SO3 and SO2 was found to involve two stages: (1) In the early stage when there existed unreacted grain surface in the particle, SO3 and SO2 mainly reacted with the left fresh grain surface. The SO3 adsorption was controlled by internal pore diffusion and surface reaction, in which internal pore diffusion played a major role. The SO3 adsorption showed a shrinking core mode. The SO2 adsorption was controlled by internal pore diffusion and surface reaction and occurred throughout the entire particle. The SO3 adsorption selectivity at the outer surface of the particle was the highest, and decreased with a decreasing dimensionless particle radius R/R-0. (2) In the later stage when the grain surface was completely reacted, the SO3 adsorption was controlled by internal pore diffusion and product-layer diffusion, in which product-layer diffusion played a major role. The SO2 adsorption was controlled by product-layer diffusion. The product-layer diffusion coefficient in the SO3 adsorption process was significantly higher than that of the SO2 adsorption, so SO3 was still significantly adsorbed in the later stage. The adsorption process of Ca(OH)(2) under different particle structure parameters showed that decreasing the particle radius and increasing the particle porosity and specific surface area increased the SO3 removal efficiency as well as the total conversion of Ca(OH)(2). Decreasing the particle radius and the specific surface area and increasing the particle porosity increased the SO3 adsorption selectivity by Ca(OH)(2). When preparing industrial adsorbents, the optimization of the particle porous structure should be given attention. (C) 2021 Elsevier Ltd. All rights reserved.

Adsorption equilibrium and kinetics for SO 2, NO, CO 2 on zeolites FAU and LTA

Adsorption-Oxidation Reaction Mechanism of NO on Na-ZSM-5 Molecular Sieves with a High Si/Al Ratio at Ambient Temperature

Competitive Adsorption of Moisture and SO2 for Carbon Dioxide Capture by Zeolites FAU 13X and LTA 5A

Effects of different alkali metal cations in FAU zeolites on the separation performance of CO2/N2O

CO2 Adsorption by Polyamine-Based Protic Ionic Liquid-Functionalized Mesoporous Silica: Regenerability and Influence of Flue Gas Contaminants

Synthesis of NaY Zeolite and their CO<sub>2</sub> Adsorption Properties

Molecular Simulation of Adsorption of CO2 from a Combustion Exhaust Mixture of Zeolites with Different Topological Structures

Molecular Simulation of Adsorption Separation of CO2 from Combustion Exhaust Mixture of Commercial Zeolites

Adsorption of SO2 over Alkali Metal Ion-exchanged ZSM-5 zeolites.

Adsorption Equilibria of CO2, CH4, N2, O2, and Ar on High Silica Zeolites

Integrated two-stage adsorption for selective removal of CO2 and SO2 by amine-functionalized SBA-15

Oxidative adsorption mechanism-based screening of zeolites for deep purification and recycling of NOx from humid gases

Study On the Adsorption Performance of Zeolite Molecular Sieve for CO2

Process Analysis of SO3 Removal by Ca(OH)2 Particles from Flue Gas

Recent Developments and Consideration Issues in Solid Adsorbents for CO 2 Capture from Flue Gas

Physisorption of SO 2 by carbonaceous model adsorbents with tunable hierarchical pore configurations: Experiment and simulation

Adsorption separation of carbon dioxide, methane, and nitrogen on Hβ and Na-exchanged β-zeolite

Adsorption kinetics of CO2, CO, N2 and CH4 on zeolite LiX pellet and activated carbon granule

Adsorption of CO2, CH4, N2O, and N2 on MOF-5, MOF-177, and Zeolite 5A

Density functional theory study of high-temperature CO2 adsorption by Li2ZrO3: Effect of typical flue gas components on adsorption energy and electronic properties

Enhancing the CO2, CH4, and N2 adsorption and kinetic performance on FAU zeolites for CO2 capture from flue gas by metal incorporation technique