Abstract:Current mode logic (CML) circuits have been widely used in high-speed data transceivers. The lower-voltage-swing makes the switching speed of CML much higher than the static logic can achieve, so it is worthy to adopt the CML circuits at the cost of higher power consumption in the high-speed applications. In order to obtain a better power efficiency (Frequency/power) in CML, it is critical to reduce the power consumption while maintaining the high operating frequency. This paper proposes an alternative approach by building the CML circuits with tunneling-field-effect-transistor (Tunnel FETs or TFETs) to achieve a high-throughput, low-voltage interface circuit design. By taking advantage of its steep subthreshold slope (less than 60 mV/dec), TFET exhibits the same on/off current ratio at the input voltage swing interval much lower than that of the MOSFETs, which enables the supply voltage scaling in CML circuits. For a design target data-rate (20 Gbps for multiplexer and 50 Gbps for buffer), our simulations show that the proposed TFET CML circuits are able to reduce the supply voltage from 0.6 V in conventional Si FinFET CML circuits to as low as 0.3 V while using the same constant tail current. As a result, a power consumption reduction of approximately 50% is achieved by the proposed TFET CML circuits, making the TFET CML approach a promising candidate for future low-power, high-performance applications.

Low Power Multilevel Current-Mode Interconnect System with RLC Model

An Equivalent Circuit Model with Current Return Path Effects for On-Chip Interconnect Up to 80 Ghz

Two 10Gb/s/pin Low-Power Interconnect Methods for 3D ICs

Transfer Functions of On-Chip Global Interconnects Based on Distributed RLCG Interconnects Model

Experimental Characterization of On-Chip Inductor and Capacitor Interconnect: Part I. Series Case

Carbon Nanotube Based Delay Model For High Speed Energy Efficient on Chip Data Transmission Using: Current Mode Technique

Energy Optimization for RC and RLC Interconnect Design in Low Power VLSI

The optimization design method of low power current-mode interconnect circuit based fast approach

Low-power High-Speed Current Mode Logic Using Tunnel-FETs

Low-latency low-power scheme for on-chip global interconnects

Low Frequency Operation Control Method for Modular Multilevel Converter Based on Improved Arm Current Prediction

A Low-Latency and Low-Power Hybrid Insertion Methodology for Global Interconnects in VDSM Designs

Low Power Repeaters Driving Rlc Interconnects with Delay and Bandwidth Constraints

Power-driven NoC design optimization with low swing interconnect

Analysis of on-chip inductance effects for distributed RLC interconnects

The Low-power Design in System Level Using Current-steering Architecture

Design of Low-Power High-Speed Current Mode Dual-Modulus Prescaler with Inductive Peaking Structure

Design of Low Voltage Low Power Current-Mode CMOS Circuits Based on Parallel Switches

An Ultra Low Voltage Energy Efficient Level Shifter With Current Limiter and Improved Split-Controlled Inverter

Research on Sub-Module Fluctuating Power Decoupling Strategy for Modular Multilevel Converter-Based Medium-Voltage Motor Drive System with Wide Speed Range

Robust Current-Mode On-Chip Interconnect Signaling Scheme in Deep Submicron