Abstract:Explosives combustion is primarily classified into conductive and convective combustion. In situations where confinement is sufficiently strong, the instantaneous high pressure generated by convective combustion in cracks can cause rapid fragmentation of the explosive matrix, resulting in a significant increase in the combustion surface area and triggering a high-intensity reaction with potentially catastrophic consequences. Therefore, the study of convective combustion in cracks is crucial for ensuring the safety of weapons and explosives. Previous simulation studies have primarily used finite element analysis software, which has excellent performance in handling explosive detonation processes. However, its accuracy in describing gas behavior between explosives and constrained containers is limited. This study divides the combustion process of a pre-cracked explosive in a confined space into four stages based on reasonable assumptions and simplifications. We developed a simulation method that combines the Arrhenius formula with the MWSD model to model the combustion rate of the explosive. By introducing a correction coefficient, Con, to the Arrhenius formula, the formula and MWSD model control the first and third stages of explosive combustion, respectively, while smoothly transitioning during the second stage. We used this method to numerically simulate the experimental results of Shang Hailin et al. on a crack width of 50 μm. The simulation results include the temperature field and pressure field of the first three stages of explosive combustion and the pressure rise curve of the pressure measurement point at the same location, as in the experiment. The simulation results are consistent with the experimental results.

Study on margin validating method of the first element in explosive device

Probability Distribution and Determination of Blast Loading During Structural Blast Resistant Study

Research on Double Margin Coefficient Design Method of Slapper Detonator

Study on evaluation method for driving fragment ability of explosives

Method of Determining the Critical Impact Velocity of Energetic Devices

A Calculation Instrument for the Sensitivity Test of Initiating Explosive Device

Performance reliability evaluation of explosive initiator based on Bayes-Bootstrap method

Study on the Distribution Model of Exploding Foil Initiator's Ignition Sensitivity

Design and Experimental Study of the Explosive Release Device with Four Tunnels

A COUPLED FINITE DIFFERENCE MATERIAL POINT METHOD AND ITS APPLICATION IN SECURITY PROTECTION

Simulation and Test of a MEMS Arming Device for a Fuze

Reactions of a high explosive under low intensity impact with adjustable amplitude and duration

Numerical Study of PBX 9501 Explosive Combustion Process in Confined Space

Experimental and Numerical Calculation Study on Shock Sensitivity of Aluminum Explosive

Study on Separation Dynamics of Explosive Bolt and Test Verification

Design and Performance of a Micro-Scale Detonation Train with a Built-in Pyrotechnic MEMS-based Safety and Arming Device

Test to Determine the Response Level of Heterogeneous Explosive by Fragment Shock Initiation

Meso-Simulation and Experimental Research on the Mechanical Behavior of an Energetic Explosive

Comprehensive Evaluation Method for Falling Points' Dispersion of Ballistic Missile

EXPERIMENTAL MEASUREMENTS OF MECHANICAL PRESPONSE OF TNT AND SIMULATIVE EXPLOSIVES TO DYNA MIC COMPRESSION LOADING AND STUDIES OF THEIR CONSTITUTIVE RELATI ONSHIP

A Method of Computer Numerical Modeling of Mechanical Response of Energetic Materials to Confined Triaxial Dynamic Compression