Abstract:To study the blast resistance and damage rule of ultra-high toughness cementitious composites (UHTCC) subjected to blast by embedded explosives, blast resistance tests of embedded explosives were carried out on UHTCC and high-strength concrete (HSC) with different embedded depths of explosives. The damage patterns of the targets of the two materials were obtained. Using the test results of contact explosion, the blast resistance parameters of the above two materials were calculated. The test results show that UHTCC has better blast resistance than high-strength concrete under the same test conditions. To further explore the influence of compressive strength, tensile strength and tensile toughness on the blast resistance of UHTCC targets to embedded explosives, the improved K&C model was used to numerically simulate the UHTCC target subjected to blast by explosives with an embedded depth of 40 mm. The simulation results were basically consistent with the experimental results. According to the results of numerical simulation, the rule that the attenuation speed of the explosion shock wave along the radial direction of target was greater than that along the axial direction was obtained, which verified the validity of the model. Then, by adjusting the parameters related to the compressive strength, tensile strength and tensile toughness in the modified K&C model, the damage patterns of the UHTCC targets with different compressive and tensile strengths and tensile toughness were predicted. It is found that enhancing the toughness of UHTCC can effectively prevent the target from undergoing overall damage, increasing the tensile strength of UHTCC can reduce the cratering diameter of the blasting surface, and increasing the compressive strength of the material has no obvious effect on reducing the cratering size. These studies can provide a basis for the application of UHTCC materials in protection engineering.

Test to Determine the Response Level of Heterogeneous Explosive by Fragment Shock Initiation

Shock Initiation of Covered Flake JH‐2 High Explosive by Simultaneous Impact of Multiple Fragments

Anti-explosion Tests and Numerical Simulations of Ultra-High Toughness Cementitious Composites Subjected to Blast by Embedded Explosives

Initiation of Shielded High Explosive Impacted by Energetic Fragment

Study on evaluation method for driving fragment ability of explosives

Method of Determining the Critical Impact Velocity of Energetic Devices

Experimental Investigation on the Enhancing Effect of Reactive Materials on Explosion Fireballs and Shock Waves of Composite Charges

Effect of explosives charges types on the jet characteristics, penetration performance and fragmentation patterns of shaped charges

Numerical Simulation Study on Impact Initiation on Shielded Charge Using Hypervelocity Composite-Structure Reactive Fragments

Experimental study on explosion dispersion process of a multi-layer composite charge under different initiation modes

Reactions of a high explosive under low intensity impact with adjustable amplitude and duration

Study on Axial Dispersion Characteristics of Double-Layer Prefabricated Fragments

Investigation of the Fracture and Fragmentation of Implosively Driven Thin-Walled Cylindrical Shell: From Thermodynamic Analysis to CDEM Simulation

Method of Evaluating Energy Released by a Warhead Charge Based on Average Fragment Quality

Response Amplification Study of the Simulated Projectile under Typical Boundary Conditions

Specimen size effect of explosive sensitivity under low velocity impact

Dynamic response of UHMWPE plates under combined shock and fragment loading

Study on Preparation and Performance Test of the Flexible Explosive with Higher Energy, Lower Sensitivity

Explosion Temperature and Dispersion Characteristics of Composite Charges Based on Different Non-detonative Materials

Numerical Simulation of the Effect of Blast Shock Wave on Target Plate

Hetero‐blast from a structural reactive material cylinder under explosive loading