Abstract:Underwater manipulators are important robotic tools in the exploration of the ocean environment. Up to now, most existing underwater manipulators are rigid and with fixed 5 or 7 degrees of freedom (DOF), which may not be very suitable for some complicated underwater scenarios (e.g., pipe networks, narrow deep cavities, etc.). The biomimetic concept of muscles and tendons is also considered as continuum manipulators, but load capacity and operation accuracy are their essential drawbacks and thus limit their practical applications. Recently, the cable-driven technique has been developed for manipulators, which can include numerous joints and hyper-redundant DOF to execute tasks with dexterity and adaptability and thus they have strong potential for these complex underwater applications. In this paper, the design of a novel cable-driven hyper-redundant manipulator (CDHRM) is introduced, which is driven by multiple cables passing through the tubular structure from the base to the end-effector, and the joint numbers can be extended and decided by the specific underwater task requirements. The kinematic analysis of the proposed CDHRM is given which includes two parts: the cable-joint kinematics and the joint-end kinematics. The geometric relationship between the cable length and the joint angles are derived via the established geometric model for the cable-joint kinematics, and the projection relationship between the joint angles and end-effector’s pose is established via the spatial coordinate transformation matrix for the joint-end kinematics. Thus, the complex mapping relationships among the cables, joints and end-effectors are clearly achieved. To implement precise control, the kinematic control scheme is developed for the CDHRM with series-parallel connections and hyper-redundancy to achieve good tracking performance. The experiment on a real CDHRM system with five joints is carried out and the results verify the accuracy of kinematics solution, and the effectiveness of the proposed control design. Particularly, three experiments are tested in the underwater environment, which verifies its good tracking performance, load carrying and grasping capacity.

Dynamic Control of a Cable-Driven Humanoid-Shoulder Joint Based on Backstepping Technique

Dynamic control of a 3-DOF cable-driven robot based on backstepping technique

Tension Optimization and Control of a Cable-driven Humanoid Shoulder with Joint Angle Feedback

Dynamic Analysis of Cable-Driven Humanoid Arm Based on Lagrange’s Equation

Mechanism Design and Tension Analysis of a Cable-driven Humanoid-arm Manipulator with Joint Angle Feedback

Dynamic control with tension compensation of a 3-DOF cable-driven parallel manipulator

Dual-Loop Control of Cable-Driven Snake-like Robots

Design and Kinematic Control of the Cable-Driven Hyper-Redundant Manipulator for Potential Underwater Applications

Kinematics, Dynamics, and Control of a Cable-Driven Hyper-Redundant Manipulator

Kinematic Analysis and Simulation of a 7-DOF Cable-Driven Manipulator

Stiffness Optimization of Cable-Driven Humanoid Manipulators

Dynamic Control of Cable Driven Parallel Robots with Unknown Cable Stiffness: a Joint Space Approach

Tension Optimization for the Dynamic Model of Cable-Driven Humanoid Arm

Non-smooth Dynamical Analysis and Experimental Validation of the Cable-Suspended Parallel Manipulator

Dynamic Modeling and Tension Analysis of a 7-DOF Cable-Driven Robotic Arm

Kinematics Control for a 7-DOF Cable-Driven Anthropomorphic Arm.

Development of a linear decoupling cable-driven manipulator with independent driving joints ,

Forward Kinematics and Workspace Analysis for a 7-DOF Cable-Driven Humanoid Arm

Deep reinforcement learning and decoupling proportional-integral-derivative control of a humanoid cable-driven hybrid robot

Hybrid Tension-Position Control of Cable-Driven Serial Manipulator to Improve Accuracy and Avoid Cable Slack and Breakage

A Closed-Loop Controller for Cable-Driven Hyper-Redundant Manipulator with Joint Angle Sensors.