Study on the Preparation of Silicon-Based Anode Materials with Porous Structure by Etching
Yankun Wang,Li Wenhao,Junhao Tan,Yuping Chen,Lei Zhou,Xiaolan Cai
DOI: https://doi.org/10.1080/10584587.2024.2324682
2024-10-25
Integrated Ferroelectrics
Abstract:Silicon has the advantages of high specific capacity (4200 mAh/g), low lithium potential and abundant reserves, and is considered to be one of the most suitable materials for replacing graphite negative electrode. However, the commercial silicon particle size is too large to be used directly as an electrode material, and the silicon material will undergo huge volume expansion during the lithium insertion process, resulting in the fragmentation of the active substance falling off from the fluid collector, resulting in a sharp decline in battery capacity. This defect seriously affects the commercial application of silicon-based anode materials. In this paper, a kind of silicon anode material with porous structure is designed for the defect of silicon anode material. The aluminum-silicon alloy prepared by atomization method presents a three-dimensional porous spherical structure after etching, and the abundant holes reserve space for the volume expansion during the process of lithium silicon embedding and improve the transmission rate of lithium ions. It was found that when the silicon content was 12%, the reversible specific capacity of the material was 1269 mAh/g at 4000 mA/g current density, and the capacity retention rate of 100 cycles relative to the fourth cycle was 59.5%. Compared with ball-ground silicon, the capacity retention rate is increased by 25.7%. Therefore, this paper provides a new idea for the design of porous silicon-based anode materials.
engineering, electrical & electronic,physics, condensed matter, applied