Abstract:The aerodynamic design and optimization of modern centrifugal compressors are inseparable from computational fluid dynamics (CFD) tools. In a design environment, CFD simulations are expected to predict compressor performance characteristics with reasonable accuracy. Turbulence models and model simplification can play a significant role in the discrepancy between analysis and reality. To investigate the influence of turbulence models on aerodynamic analysis results of centrifugal compressors, the National Aeronautics and Space Administration's high efficiency centrifugal compressor stage is selected as the test vehicle. Six eddy-viscosity models, namely, Spalart–Allmaras (SA), standard k–epsilon (k−ε), renormalization group k–epsilon (RNG k−ε), Wilcox k–omega (k−ω), shear stress transport (SST), and SST-reattachment modification (SST-RM) are considered. In all numerical analyses, measured surface roughness is included with the aim of improving numerical solution accuracy. Although some discrepancies exist, the compressor performance characteristics predicted by the k−ω model are in satisfactory agreement with the test data over the whole speedline. The k−ε model overpredicts the isentropic efficiency than the other models, while the SST-RM model underestimates the total pressure ratio in the near-stall region. The RNG k−ε model matches high flow characteristics but overestimates the choked mass flow rate. The SST model obtains a similar operating range with the test data but underestimates the compressor's isentropic efficiency and total pressure ratio, while the SA model totally overestimates the compressor characteristics due to the wall function. Furthermore, variations caused by turbulence models are discussed together with the flow field analysis. Finally, to verify the impact of the impeller backplate bleed cavity, an additional simulation is conducted that specifically accounts for this feature.

Comparison of Two Two-Equation Turbulence Model Used for the Numerical Simulation of Underwater Ammunition Fuze Turbine Flow Field

Numerical Simulation of a Turbulence Flow in the Cut-off Valve by RNG k- ε Turbulence Model

Comparison Among k-ε Turbulence Models in CFD Analysis on Flow Field Around a Car

Assessment of a Novel K–ω Turbulence Model for Transonic Centrifugal Impeller Simulations

Comparison study of turbulence models in numerical simulation of multi-jets impinging injectors

Analysis of Two-Phase Cavitating Flow with Two-Fluid Model Using Integrated Boltzmann Equations

Calculation of Tip Vortex Cavitation Flows Around Three-Dimensional Hydrofoils and Propellers Using a Nonlinear K-Ε Turbulence Model

Comparative Study of Different Turbulence Models for Cavitational Flows Around NACA0012 Hydrofoil

Comparisons of different turbulence models based on the flow around a bottom-mounted cylinder

Comparison of SST K-ω and Smagorinsky Model in Cavitation Simulation Around NACA0012

Influence of turbulence model on performance prediction of mixed-flow pump

Investigation of turbulence models for aerodynamic analysis of a high-pressure-ratio centrifugal compressor

Application of different turbulence models in numerical simulation of mixed-flow pump and its evaluation

Uncertainty Analysis on K-Ε Turbulence Model in the Prediction of Subcooled Boiling in Vertical Pipes

A comparative evaluation of turbulence models for simulation of unsteady cavitating flows

EFFECT OF VARIOUS TURBULENCE MODELS ON SIMULATED RESULTS OF CAVITATING FLOW

Application of Two Turbulence Models for Computation of Cavitating Flows in a Centrifugal Pump

On the accuracy of turbulence models for CFD simulations of vertical axis wind turbines

Numerical and experimental turbulence studies on shallow open channel flows

Numerical Analysis of Flow in A Francis Turbine on an Equal Critical Cavitation Coefficient Line

Numerical and Experimental Analysis of Vortex Profiles in Gravitational Water Vortex Hydraulic Turbines