Abstract:The physical mechanism of flow unsteadiness is one of the key problems in cavitating flow. Significant efforts have been exerted to explain the cavitation-vortex interaction mechanism. As well, the process of kinetic energy transport during the evolution of unsteady cavitating flow must be elucidated. In this work, 2D calculations of cavitating flow around a NACA66 hydrofoil were performed based on the open source software OpenFOAM. The modified shear stress transport k-ω turbulence model, which considers curvature and turbulent eddy viscosity corrections, was employed to close the governing equations. The Schnerr-Sauer cavitation model was adopted to capture the cavitation phase change process. Numerical results showed reasonable consistency with the results of the experiments conducted by Leroux et al. (2004). The results showed that cavitation promotes turbulence intensity and flow unsteadiness around the hydrofoil. During the attached sheet cavity growth stage, high-value regions of turbulent kinetic energy are located substantially at the interface of the cavity, particularly at the rear portion of the cavity region. During the cloud cavity shed-off stage, the cavity begins to break off and the maximum value of turbulent kinetic energy is observed inside the shed cavity. Finally, the influence of cavitation on the turbulence intensity is illustrated using the turbulent kinetic energy transport equation, which shows that the pressure diffusion and turbulent transport terms dominate as cavitation occurs. In addition, cavitation promotes turbulence production and increases dissipation with fluid viscosity and flow unsteadiness. The viscous transport term only acts in the cavitation shedding stage under large-scale vortex shedding. Overall, these findings are of considerable interest in engineering applications.

Calculation of Tip Vortex Cavitation Flows Around Three-Dimensional Hydrofoils and Propellers Using a Nonlinear K-Ε Turbulence Model

Effect of Relative Positions between Blade and Volute Tongue on Prediction of Performance in Simulation of Centrifugal Pump

Numerical Simulation of a Turbulence Flow in the Cut-off Valve by RNG k- ε Turbulence Model

Simulation of vortex induced vibration of turbulent flow around a circular cylinder by plane turbulent models

Numerical study on wetted and cavitating tip-vortical flows around an elliptical hydrofoil: Interplay of cavitation, vortices, and turbulence

Calculation of Cavitation Evolution and Associated Turbulent Kinetic Energy Transport Around a NACA66 Hydrofoil

Tomographic Particle Image Velocimetry Investigation on Flow Characteristics and Pressure–velocity Relation of a Near-Field Tip Vortex

Numerical Simulation Of Unsteady Flow Characteristics For Cavitation Around A 3-D Hydrofoil

An Experimental Study on Near-Field Tip Vortex of an Elliptical Hydrofoil Using Tomographic Particle Image Velocimetry

Dynamics of cavitating tip vortex

Experimental Study on Pressure-Velocity Relation of Near-Field Tip Vortex Using Tomographic PIV

Unsteady Prediction of Cavitating Flow Around a Three Dimensional Hydrofoil by Using a Modified RNG K-Ε Model

Numerical Simulation for the Tip Leakage Vortex Cavitation

Numerical Simulation of Three Dimensional Cavitation Shedding Dynamics with Special Emphasis on Cavitation–vortex Interaction

Unsteady Numerical Simulation of Cavitating Turbulent Flow Around A Highly Skewed Model Marine Propeller

3D Study of Cloud Cavitation on a Circular Leading-Edge Hydrofoil Using RANS Approaches

Numerical Simulation of Cavitation Around a Hydrofoil and Evaluation of a RNG Κ-Ε Model

Numerical Simulation and Analysis of Unsteady Flow Characteristics in Centrifugal Pump Volute

Partially-Averaged Navier-Stokes method with modified k-ε model for cavitating flow around a marine propeller in a non-uniform wake

Numerical Simulation of Separated Flows over Slender Body at High-Angle-of-attack with K-Ε Model Comforming Realizability

Application of Two Turbulence Models for Computation of Cavitating Flows in a Centrifugal Pump