Abstract:Abstract This work models the spatial decay of freestream turbulence using three different commercial computational fluid dynamics (CFD) codes: Fluent, star-ccm+, and cfx. The two-equation shear stress transport k–ω (SST-k–ω) steady Reynolds-averaged-Navier–Stokes (RANS) model was used, within each of these three different commercial codes, and the modeling variations were analyzed. Comparison of the results from the SST-k–ω model with experiments and large eddy simulation (LES) (carried out using star-ccm+) were also made, which reveal that all the commercial CFD codes demonstrate either a higher or slower rate of spatial turbulent kinetic energy (TKE) decay. Attempts were then made to unify the resultant modeling approach between these three CFD tools, by careful manipulation of the inlet boundary conditions and subsequent fine-tuning of the SST-k–ω model constant (β∞∗). The results obtained not only displayed uniformity among the three CFD codes but also demonstrated a much better agreement to the experiments and the LES results. Thereafter, the optimized model coefficient (β∞∗) was integrated with the three-equation k–kl–ω transition model to examine its applicability in modeling a turbulent boundary layer flow over a flat plate with low incoming turbulence. The results showed good agreement with the theoretical boundary layer correlations, with correct prediction of the transition location. The findings from this study can be used as a suitable modeling method to accurately model the effects of freestream turbulence on bluff-body and boundary layer flows.

Numerical and experimental turbulence studies on shallow open channel flows

Simulation of vertical round turbulent jets in shallow water

Numerical and Experimental Analysis of Shallow Turbulent Flow over Complex Roughness Beds

Numerical Simulation of a Turbulence Flow in the Cut-off Valve by RNG k- ε Turbulence Model

Depth-averaged Turbulence Models for Flow Simulation at Equal-Width Open-Channel Junction

A Comparison Of Numerical-Model Experiments Of Free-Surface Flow Over Topography With Flume And Field Observations

Numerical Simulation of Separated Flows over Slender Body at High-Angle-of-attack with K-Ε Model Comforming Realizability

SPHysics simulation of laboratory shallow free surface turbulent flows over a rough bed

SPH modelling of depth-limited turbulent open channel flows over rough boundaries

Experimental research and turbulent flow simulation of the updraft free-exit-flow hydropower turbine system

Research of Applicability of Several Turbulence Models in Numerical Simulation for Flow in Pipeline

Numerical simulation of 3-D turbulent flow through turbine runners

Numerical Simulation of Turbulent Flow in Helically Coiled Open-Channels with Compound Cross-Sections

Numerical Modeling of Freestream Turbulence Decay Using Different Commercial Computational Fluid Dynamics Codes

Numerical and Experimental Analysis of Vortex Profiles in Gravitational Water Vortex Hydraulic Turbines

Numerical simulation and abrasion prediction of two-phase turbulent flows through hydraulic turbine guide vanes

A General Two-Phase Turbulent Flow Model Applied to the Study of Sediment Transport in Open Channels

Numerical simulations of flow inside a stone protection layer with a modified k-ω turbulence model

Numerical Simulation of 2D Jet-to-Crossflow Heat Transfer with Different Turbulence Models

Assessment of Six Turbulence Models for Modeling and Predicting Narrow Passage Flows, Part 2: Pin Fin Arrays

Three-dimensional smoothed particle hydrodynamics modeling of near-shore current flows over rough topographic surface