Abstract:Nanostructured zinc oxide (ZnO) for gas sensing application has been prepared by using normal and oblique angle sputtering deposition techniques under different substrate temperatures. Oblique angle plasma beam deposition is demonstrated effectively growing large-area uniformly aligned and inclined ZnO nanorod arrays on catalyst-free silicon substrate due to a self-shadowing mechanism, whereas normal radio frequency sputtering deposition yields nanoparticles as island growth mode. Furthermore, the density of the nanorod arrays is dependent on the incident angle of ZnO plasma beam. With an increase of the incident flux angle, large inter spacing was induced, resulting in sparser nanorod arrays. The nanorod arrays grown with an incident angle of 70 have an average diameter of similar to 150-300 nm and length of similar to 700-750 nm. The experimental data from characterization of the samples indicates that the obtained samples at different substrate temperatures and incident angles have wurtzite structure with a c-axis orientation.Sensing characterization reveals that the nanorod-based sensor shows higher sensitivity, faster response and recovery time, as well as better reproducibility than that of nanoparticle-based gas sensor to 100 ppm hydrogen and methane at low operating temperature below 150 degrees C due to the porosity and large grain boundaries of the nanorod arrays. It demonstrates that oblique angle of sputtering deposition is a simple, inexpensive synthesis process to get high-porosity nanostructures and as a result, improves the sensing properties of fabricated ZnO sensors, which permits us to obtain sensors with high sensitivity, low operating temperature and stability. (C) 2011 Elsevier B.V. All rights reserved.

Sensing Performances of ZnO Nanostructures Grown under Different Oxygen Pressures to Hydrogen

Nanostructures and Sensing Properties of ZnO Prepared Using Normal and Oblique Angle Deposition Techniques

Hydrothermal Synthesis and Growth Mechanisms of Different ZnO Nanostructures and Their Gas-Sensing Properties

Gas Sensing Properties of ZnO-SnO2 Nanostructures.

Controllable Preparation and Gas Sensing Performance of Nanosized ZnO with Different Micromorphologies

ZnO Nanosheets Abundant in Oxygen Vacancies Derived from Metal‐Organic Frameworks for ppb‐Level Gas Sensing

Synthesis of ZnO nanosheet arrays with exposed (100) facets for gas sensing applications.

Controllable Growth of Single-Crystalline Zinc Oxide Nanosheets under Ambient Condition Toward Ammonia Sensing with Ultrahigh Selectivity and Sensitivity

Optical Emission Based Oxygen Sensing by ZnO Nanoparticles

Nanoporous ZnO structure prepared by HiPIMS sputtering for enhanced ozone gas detection

Preparation and Gas Sensing Properties of ZnO/SnO2 Hierarchical Nanostructures

Porous and Single-Crystalline ZnO Nanobelts: Fabrication with Annealing Precursor Nanobelts, and Gas-Sensing and Optoelectronic Performance

Synthesis and H2 Gas-Sensing Property of ZnO Nanobelts

Defect-Controlled Gas Sensing Property of Nanostructured ZnO Films

Oxygen Defect Influenced Gas Sensing Properties of Zno Polyhedral Structures

Controllable Synthesis of ZnO Nanoflakes with Exposed (10(1)over-bar0) for Enhanced Gas Sensing Performance

Enhanced gas sensing performance of Li-doped ZnO nanoparticle film by the synergistic effect of oxygen interstitials and oxygen vacancies

Low-pressure hydrogen sensing mechanism based on the field emission of defect-controlled ZnO nanorods

Chemical Vapor Deposition Preparation of Nanostructured ZnO Particles and Their Gas-Sensing Properties

Synthesis ofporous single-crystalline ZnO nanoplates and their sensing properties to indoor air pollutants

A ZnO Gas Sensor with an Abnormal Response to Hydrogen