Abstract:Two fluorescent high‐performance polymers based on dicyanoarylamine luminogens were readily synthesized via polycondensation. Both polymers were soluble in several polar aprotic solvents and exhibited useful levels of thermal stability. The polymers were emissive in both solution and solid film states, thereby demonstrating the aggregation‐induced fluorescence changes. Introduction Fluorescent high‐performance polymers have been extensively used in designing optoelectronic devices due to their low cost, excellent thermal stability, high mechanical strength, low flammability, good chemical and radiation resistance, and good electronic properties. While conventional organic luminophores fluoresce strongly in dilute solutions, they suffer from undesirable aggregation‐caused quenching in concentrated solutions and in the solid state due to extensive π‐π stacking interactions and formation of delocalized excitons or excimers. This phenomenon leads to non‐radiative decay thus, decreased fluorescence emission of the material in the solid film state, which significantly limits their real‐world application as solid light‐emitting materials. Objectives To develop new high‐performance polymers with high photo luminescent efficiency, good processability, film‐forming properties, which could potentially be used in the fabrication of optoelectronic devices. Methods The preparation of the polyimide DiCN‐PI was carried out by a one‐step, high‐temperature solution imidization method. In this procedure, 1,2,4,5‐cyclohexanetetracarboxylic dianhydride and the diamine were polymerized in 1‐methyl‐2‐pyrrolidinone and γ‐butyrolactone co‐solvent at 180°C for 15 hours in the presence of isoquinoline as catalyst. On the other hand, polyamide DiCN‐PA was synthesized according to the direct phosphorylation polycondensation technique described by Yamazaki from diamine and trans‐1,4‐cyclohexanedicarboxylic acid using triphenyl phosphite and pyridine as condensing agents. Results and Discussion Both polymers were soluble in several polar aprotic solvents and exhibited useful levels of thermal stability. The polymers were emissive with PL emission bands around 555 (bluish‐green) and 498 (cyan) nm in dilute 1‐methyl‐2‐pyrrolidinone solutions for polyimide and polyamide, respectively. In the solid film state, the polymers emit light green and yellow colors, which simulate the PL behavior of their aggregated states, thereby demonstrating aggregation‐induced fluorescence changes. Conclusions These results indicate that the incorporation of bulky dicyanoarylamine moiety and alicyclic monomer units into the rigid polymer backbones effectively disrupted the planarity of the chain packing which resulted to the fluorescent high‐performance polymers with desired properties for potential optoelectronic applications.

Polymerizing Nonfluorescent Monomers Without Incorporating Any Fluorescent Agent Produces Strong Fluorescent Polymers

Luminescent and light refractive polymers: Synthesis and optical and photonic properties of poly(arylene ethynylene)s carrying silole and tetraphenylethene luminogenic units

Photoluminescent supramolecular hyperbranched polymer without conventional chromophores based on inclusion complexation.

Anionic polymerization of nonaromatic maleimide to achieve full-color nonconventional luminescence

Fluorescence in “Nonfluorescent” Polymers

Enabling nonconjugated polyesters emit full-spectrum fluorescence from blue to near-infrared

Water-soluble fluorescent nanoparticles without distinct aggregation of conjugated polymer chains

Electron-beam-activated Light-Emitting Polymer Nanofibers.

Designing Nonconventional Luminescent Materials with Efficient Emission in Dilute Solutions via Modulation of Dynamic Hydrogen Bonds

Preparation, Morphology, and Biolabeling of Fluorescent Nanoparticles Based on Conjugated Polymers by Emulsion Polymerization

Characterization and Fluorescence Properties of Thiophene-Modified Π-Conjugated Nickel Poly-Yne Polymers

Polymerization Initiated by Inherent Free Radicals on Nanoparticle Surfaces: A Simple Method of Obtaining Ultrastable (zno)polymer Core–Shell Nanoparticles with Strong Blue Fluorescence

Synthesis of Soluble and Fluorescent Hybrid Polymer Using Organic/inorganic Assemblies as Building Blocks

Nonconventional Luminescent Piperazine-Containing Hyperbranched Polysiloxanes with Pure n-electron

Poly(ε-caprolactone) Modified Organic Dyes Nanoparticles for Noninvasive Long Term Fluorescence Imaging

Nonconventional Luminescent Polymers: Emission Regulation and Applications

One-pot preparation of nonconventional luminescent polymer gels driven by polymerization

A New Family Of Thermoplastic Photoluminescence Polymers

Improving the photostability of fluorescent dyes by polymer nano‐insulating layer

Synthesis, characterization, and photophysical properties of dicyanoarylamine‐based semi‐aromatic polymers