Abstract:Two fluorescent high‐performance polymers based on dicyanoarylamine luminogens were readily synthesized via polycondensation. Both polymers were soluble in several polar aprotic solvents and exhibited useful levels of thermal stability. The polymers were emissive in both solution and solid film states, thereby demonstrating the aggregation‐induced fluorescence changes. Introduction Fluorescent high‐performance polymers have been extensively used in designing optoelectronic devices due to their low cost, excellent thermal stability, high mechanical strength, low flammability, good chemical and radiation resistance, and good electronic properties. While conventional organic luminophores fluoresce strongly in dilute solutions, they suffer from undesirable aggregation‐caused quenching in concentrated solutions and in the solid state due to extensive π‐π stacking interactions and formation of delocalized excitons or excimers. This phenomenon leads to non‐radiative decay thus, decreased fluorescence emission of the material in the solid film state, which significantly limits their real‐world application as solid light‐emitting materials. Objectives To develop new high‐performance polymers with high photo luminescent efficiency, good processability, film‐forming properties, which could potentially be used in the fabrication of optoelectronic devices. Methods The preparation of the polyimide DiCN‐PI was carried out by a one‐step, high‐temperature solution imidization method. In this procedure, 1,2,4,5‐cyclohexanetetracarboxylic dianhydride and the diamine were polymerized in 1‐methyl‐2‐pyrrolidinone and γ‐butyrolactone co‐solvent at 180°C for 15 hours in the presence of isoquinoline as catalyst. On the other hand, polyamide DiCN‐PA was synthesized according to the direct phosphorylation polycondensation technique described by Yamazaki from diamine and trans‐1,4‐cyclohexanedicarboxylic acid using triphenyl phosphite and pyridine as condensing agents. Results and Discussion Both polymers were soluble in several polar aprotic solvents and exhibited useful levels of thermal stability. The polymers were emissive with PL emission bands around 555 (bluish‐green) and 498 (cyan) nm in dilute 1‐methyl‐2‐pyrrolidinone solutions for polyimide and polyamide, respectively. In the solid film state, the polymers emit light green and yellow colors, which simulate the PL behavior of their aggregated states, thereby demonstrating aggregation‐induced fluorescence changes. Conclusions These results indicate that the incorporation of bulky dicyanoarylamine moiety and alicyclic monomer units into the rigid polymer backbones effectively disrupted the planarity of the chain packing which resulted to the fluorescent high‐performance polymers with desired properties for potential optoelectronic applications.

Luminescent and light refractive polymers: Synthesis and optical and photonic properties of poly(arylene ethynylene)s carrying silole and tetraphenylethene luminogenic units

Regioselective Alkyne Polyhydrosilylation: Synthesis and Photonic Properties of Poly(silylenevinylene)s

Aggregation-induced Emission of Silole Molecules and Polymers: Fundamental and Applications

Synthesis and Light-Emitting Properties of Disubstituted Polyacetylenes Carrying Chromophoric Naphthylethynylphenyl Pendants

Silole‐containing Poly(silylenevinylene)s: Synthesis, Characterization, Aggregation‐enhanced Emission, and Explosive Detection

Thiol-Yne Click Polymerization: Regio- And Stereoselective Synthesis Of Sulfur-Rich Acetylenic Polymers With Controllable Chain Conformations And Tunable Optical Properties

Facile Polycyclotrimerization of "simple" Arylene Bipropiolates: A Metal-Free, Regioselective Route to Functional Hyperbranched Polymers with High Optical Transparency, Tunable Refractive Index, Low Chromatic Aberration, and Photoresponsive Patternability

Synthesis and Properties of Polybisthienylphenylene Derivatives As Electroluminescent Materials: Improving of the Photoluminescent Quantum Yields

New Disilyl-Substituted Poly(Phenylene Vinylene)-Related Polymers: Synthesis and Photoelectric Properties

Novel Linear and Cyclic Polyenes with Dramatic Aggregation-Induced Enhancements in Photoresponsiveness

Synthesis, characterization, and photophysical properties of dicyanoarylamine‐based semi‐aromatic polymers

Novel Light-Emitting Polymers Derived from Fluorene and Maleimide

Functional disubstituted polyacetylenes and soluble cross-linked polyenes: Effects of pendant groups or side chains on liquid crystallinity and light emission of poly(1-phenyl-l-undecyne)s

Helical and Luminescent Disubstituted Polyacetylenes: Synthesis, Helicity, and Light Emission of Poly(diphenylacetylene)s Bearing Chiral Menthyl Pendant Groups

SYNTHESIS OF NOVEL POLYFLUORENE COPOLYMERS AND ELECTROLUMINESCENCE PROPERTIES

Hydrogen-bonding dependent nontraditional fluorescence polyphenylallenes: Controlled synthesis and aggregation-induced emission behaviors

Synthesis of an electroluminescent polymer and its non-doped light-emitting diodes with stable green emission

Synthesis and Properties of Poly(1-Phenyl-1-Octyne)S Containing Stereogenic and Chromophoric Pendant Groups

A Novel Series Of Efficient Thiophene-Based Light-Emitting Conjugated Polymers And Application In Polymer Light-Emitting Diodes

Cross-Linked Luminescent Polymers Based on β-Diketone-Modified Polysiloxanes and Organoeuropiumsiloxanes

Pioneering research on blue "hot exciton" polymers and their application in solution-processed organic light-emitting diodes