Abstract:Two fluorescent high‐performance polymers based on dicyanoarylamine luminogens were readily synthesized via polycondensation. Both polymers were soluble in several polar aprotic solvents and exhibited useful levels of thermal stability. The polymers were emissive in both solution and solid film states, thereby demonstrating the aggregation‐induced fluorescence changes. Introduction Fluorescent high‐performance polymers have been extensively used in designing optoelectronic devices due to their low cost, excellent thermal stability, high mechanical strength, low flammability, good chemical and radiation resistance, and good electronic properties. While conventional organic luminophores fluoresce strongly in dilute solutions, they suffer from undesirable aggregation‐caused quenching in concentrated solutions and in the solid state due to extensive π‐π stacking interactions and formation of delocalized excitons or excimers. This phenomenon leads to non‐radiative decay thus, decreased fluorescence emission of the material in the solid film state, which significantly limits their real‐world application as solid light‐emitting materials. Objectives To develop new high‐performance polymers with high photo luminescent efficiency, good processability, film‐forming properties, which could potentially be used in the fabrication of optoelectronic devices. Methods The preparation of the polyimide DiCN‐PI was carried out by a one‐step, high‐temperature solution imidization method. In this procedure, 1,2,4,5‐cyclohexanetetracarboxylic dianhydride and the diamine were polymerized in 1‐methyl‐2‐pyrrolidinone and γ‐butyrolactone co‐solvent at 180°C for 15 hours in the presence of isoquinoline as catalyst. On the other hand, polyamide DiCN‐PA was synthesized according to the direct phosphorylation polycondensation technique described by Yamazaki from diamine and trans‐1,4‐cyclohexanedicarboxylic acid using triphenyl phosphite and pyridine as condensing agents. Results and Discussion Both polymers were soluble in several polar aprotic solvents and exhibited useful levels of thermal stability. The polymers were emissive with PL emission bands around 555 (bluish‐green) and 498 (cyan) nm in dilute 1‐methyl‐2‐pyrrolidinone solutions for polyimide and polyamide, respectively. In the solid film state, the polymers emit light green and yellow colors, which simulate the PL behavior of their aggregated states, thereby demonstrating aggregation‐induced fluorescence changes. Conclusions These results indicate that the incorporation of bulky dicyanoarylamine moiety and alicyclic monomer units into the rigid polymer backbones effectively disrupted the planarity of the chain packing which resulted to the fluorescent high‐performance polymers with desired properties for potential optoelectronic applications.

Characterization and Fluorescence Properties of Thiophene-Modified Π-Conjugated Nickel Poly-Yne Polymers

Synthesis and Light-Emitting Properties of Disubstituted Polyacetylenes Carrying Chromophoric Naphthylethynylphenyl Pendants

?-Conjugated soluble palladium poly-ynes: Synthesis and fluorescence properties

Polycyclotrimerization of aromatic diynes: Synthesis, thermal stability, and light-emitting properties of hyperbranched polyarylenes

Photoluminescence, Electroluminescence, Nonlinear Optical, and Humidity Sensitive Properties of Poly(p-diethynylbenzene) Prepared with a Nickel Acetylide Catalyst

A Novel Series Of Efficient Thiophene-Based Light-Emitting Conjugated Polymers And Application In Polymer Light-Emitting Diodes

Novel poly(phenylene ethynylene)-type conjugated polymers containing diketopyrrolopyrrole or triphenylpyrazoline units in the main chain: synthesis, characterization and photophysical properties

Synthesis and characterization of polyyne polymer containing nickel in the main chain

Pyrene-Functionalized Polyacetylenes: Synthesis and Photoluminescence Property

Novel Poly(Thienylene Ethynylene)S With Electron-Accepting Groups

Thermally stable light-emitting polymers of substituted polyacetylenes

Poly(P-Diethynylbenzene) Derivatives for Nonlinear Optics

Synthesis and Properties of Polybisthienylphenylene Derivatives As Electroluminescent Materials: Improving of the Photoluminescent Quantum Yields

Π‐conjugated Soluble Nickel–polyyne Copolymer: Synthesis and Third‐order Optical Nonlinearity

Synthesis, characterization, and fluorescence quenching of novel cationic phenyl-substituted poly(p-phenylenevinylene)s

New Disilyl-Substituted Poly(Phenylene Vinylene)-Related Polymers: Synthesis and Photoelectric Properties

Electrochromic Properties of Polymers/Copolymers Via Electrochemical Polymerization Based on Star-Shaped Thiophene Derivatives with Different Central Cores

Multicolor Conjugated Polymers Containing Thiophene/indole Moieties and the Influence of Structures on Their Photophysical Properties

Amplified Fluorescence Quenching and Electroluminescence of a Cationic Poly(p-phenylene-co-thiophene) Polyelectrolyte

Synthesis, characterization, and photophysical properties of dicyanoarylamine‐based semi‐aromatic polymers