Abstract:Hollow fiber membranes fabricated via dry/wet phase inversion method usually have two dense skin layers,which will increase its resistance of mass transport as a support membrane. It is necessary that the dense skin layer of support membrane has been eliminated to improve separation performance of composite membrane. The excellent. chemical resistance of poly(vinylidene fluoride) (PVDF) to many acids and alkalis has made it as an attractive membrane material, and then it's often fabricated as porous hollow fiber membrane by phase inversion. In the process, the formation of the skin layer is due to the rapid exchange between solvent and coagulation, so many attempts have been made to slow it, so as to control the formation of the skin layer. In this paper, it has been found that the fabrication progress becomes unstable, and the membrane prepared has noncircular lumen, when the "weak" or "soft" coagulation is used. To increase the fabrication solution stability during membrane formation, dope viscosity was focused in this experiment. Dimethyl acetamide (DMAc) was used as solvent as well as internal coagulant, and the additives including LiCl, water and surfactant Span were chosen to investigate their effect oil the viscosity of the fabrication solution. The dope viscosity will greatly increase after adding LiCl, while the variety of dope viscosity is unconcerned in the fabrication solution concentration as adding water. The homogenization and stability of the fabrication solution are improved by adding Span,and the viscosity increases at the same time. Without increasing PVDF concentration, the stability of the nascent membrane was improved by increasing the fabrication viscosity. The PVDF hollow fiber membrane with the structure of single outer skin layer and finger-like pore through the cross-section, has been successfully fabricated. The mean pore radius and water flux of the single skin hollow fiber membrane were greatly improved.

The preparation and performance characteristics of polyvinyl chloride-co-vinyl acetate (VC-co-VAc-OH) modified membranes on the non-woven fabrics

Study on preparation and performance characteristics of polyvinyl chloride-co-vinyl acetate-modified membranes on the nonwoven fabrics

Effects of Preparing Condition on PVDF Membrane Morphology

Study on Preparation and Performance of Modified Polyvinyl Chloride-co-vinyl Acetate Microfiltration Membranes

Effectiveness of a Coagulation Step and Polyester Support on Blend Polyvinylchloride Membrane Formation and Performance

The Effects Of Pretreatment Condition Of Non-Woven Fabrics On The Pvc-Co-Pvac-Oh Membrane Performances

Preparation and Characterization of Poly(vinyl Chloride)‐graft‐acrylic Acid Membrane by Electron Beam

Fabrication and Performance of a Low Operating Pressure Nanofiltration Poly(vinyl Chloride) Hollow Fiber Membrane

Preparation of Symmetric Network PVDF Membranes for Protein Adsorption Via Vapor-Induced Phase Separation

Effect of the Permeants/Polymer Interactions on the Pervaporative Separation Properties of the P(Vdf-Co-Hfp) Membrane

Modification of Porous Poly(Vinylidene Fluoride) Membrane Using Amphiphilic Polymers with Different Structures in Phase Inversion Process

Ph‐dependent Property of Carboxyl‐based Ultrafiltration Membranes Fabricated from Poly(vinyl Chloride‐ R ‐acrylic Acid)

Preparation and Characterization of PVDF/nonwoven Fabric Flat-Sheet Composite Membranes for Desalination Through Direct Contact Membrane Distillation

Effect of Additives on the Morphology and Performance of Symmetric Network PVDF Membranes

Progresses in the Modification and Application of Poly(vinyl Alcohol) Membrane

INFLUENCE OF ALCOHOL-BASED NONSOLVENTS ON THE FORMATION AND MORPHOLOGY OF PVDF MEMBRANES IN PHASE INVERSION PROCESS

Preparation and characterization of polyvinylidene fluoride (PVDF) hollow fiber membranes

Influence of Dope Viscosity on the Fabrication of Pvdf Hollow Fiber Membranes with Single Skin Layer

Preparation of antimicrobial PVDF and EVOH membranes by grafting quaternary ammonium compounds

Preparation Of Pvdf Hollow Fiber Membranes With High Adsorption Performance By One-Step Physical Coating And Chemical Cross-Linking

Preparation and Characterization of Polyacrylonitrile-Based Membranes: Effects of Internal Coagulant on Poly(acrylonitrileco-Malefic Acid) Ultrafiltration Hollow Fiber Membranes