Study On The Fabrication Accuracy Of Ceramic Parts By Direct Stereolithography Ceramic Parts Can Be Prepared Using Stereolithography By Building Composite Parts From Ceramic Powder-Loaded Resins, Followed By Simultaneous Polymer Pyrolysis And Ceramic Sintering. This Paper Describes A Systematic Study Into The Influence Of Several Parameters On The Accuracy Of Such Parts

Xiaoyong Tian,Dichen Li,Zhangwei Chen,Weizhao Zhou
DOI: https://doi.org/10.1080/17452759.2012.718492
IF: 10.6
2012-01-01
Virtual and Physical Prototyping
Abstract:Parameters in the stereolithography, drying, and sintering processes of ceramic components had significant influences on the fabrication accuracies. Taguchi's experimental design method was utilised to investigate the relationships between parameters and the fabrication accuracies. In the stereolithography process, line-width compensation had a significant influence on the part's dimensions. On the contrary, scanning speed had an insignificant effect. The vacuum-freeze drying method was used to decrease shrinkage (less than 2.0%) in the drying process. Sintering temperature was the most important factor in the sintering process. According to analysis of the influence of the ladder effect on surface roughness, small layer thickness and large inclination angle (more than 308) were proposed to improve the surface quality of the produced ceramic parts.
What problem does this paper attempt to address?