Abstract:A new type of Tenova pulsed extraction column was introduced in 2017. It is the newest generation of pulsed columns. Due to the internal equipment of this column and the lack of moving parts and the simplicity and speed of repairs and maintenance, it has been the focus of researchers in recent years. No correlations for predicting the mean drop size and drop size distribution of the Tenova column have been reported. The Sauter mean drop diameter and drop size distribution are investigated for a Tenova pulsed column with a diameter and an active height of 7.4 and 73 cm, respectively. Three standard chemical systems of isobutyl acetate-water, isobutanol-water, and toluene-water have been used. The effects of pulse intensity, dispersed and continuous phase flow rates have been taken into account. In each experiment, 200–300 drops have been analyzed in a total of 10,000 drops. The investigation covered a spectrum of physical properties, notably surface tension (within a range of 1.75–36 mN/m). Operating conditions including pulse intensity (in the range of 0.2–2 cm/s) and the flow rate of continuous and dispersed phases (in the range of 8–30 L/h) have been investigated. Methods based on artificial intelligence (AI) such as multilayer perceptron neural networks and gene expression programming were combined with a dimensional analysis approach to provide a new approach to estimating the mean drop diameter (d 32 ). Experimental results have been compared with the equations found by other researchers in similar columns. The variation of drop size distribution has also been experimentally obtained.Methods based on artificial intelligence (AI) such as multilayer perceptron neural networks and gene expression programming were combined with a dimensional analysis approach to provide a new approach to estimating the mean drop diameter (d 32 ). Experimental results have been compared with the equations found by other researchers in similar columns. The variation of drop size distribution has also been experimentally obtained.

Correlation of the Drop Size in a Modified Scheibel Extraction Column

An Improved Correlation of the Mean Drop Size in A Modified Scheibel Extraction Column

Correlation of Infinite-Dilution Diffusion Coefficients in Supercritical Fluids

CFD-PBM Simulation of Sauter Mean Diameter in a Stirred Sieve-Plate Extraction Column

Numerical studies of the influence of particles' size distribution characteristics on the gravity separation performance of Liquid-solid Fluidized Bed Separator

Construction of spinning drop tensiometer and determination of liquid-liquid interfacial tension

Forecasting Sauter mean droplet size and examining the range of droplet sizes in a Tenova liquid–liquid extraction column

An Experimental Study of Immiscible Liquid–liquid Dispersions in a Pump–mixer of Mixer–settler

A Simplified Correlation of Mass Transfer in a Pulsed Sieve Plate Extraction Column

An RTD Model of Dispersed Phase in a Modified Scheibel Extraction Column

A Fitting Formula for Predicting Droplet Mean Diameter for Various Liquid in Effervescent Atomization Spray

Hydrodynamics And Mass-Transfer Of A Sieve Plate Column For Liquid-Liquid-Extraction

Terminal Effect of Drop Coalescence on Single Drop Mass Transfer Measurements and Its Minimization

Drop Breakage in a Coalescence-Dispersion Pulsed-Sieve-plate Extraction Column

EFFECTS OF LIQUID PROPERTIES ON DROP MEAN DIAMETER IN EFFERVESCENT ATOMIZATION SPRAY

Extending Mass Transfer Correlations For Packed Three-Phase Distillation Simulation: A Hierarchical Parameter Estimation Methodology

Dispersed Phase Holdup in a Tall and Low Plate Free Area Liquid Pulsed Sieve-Plate Extraction Column

Numerical Investigation of SO2 Absorption into a Droplet: Deformation and Internal Flow Facilitating Mass Transfer

An Experimental Study on Single Drop Rising in a Low Interfacial Tension Liquid–liquid System

Developing RSM-CCD model as the essential steps in the description of mass transfer efficiency of Scheibel exctractor

A new method to quantify droplet size distribution based on Monte Carlo simulation in liquid–liquid solvent extraction