Abstract:Optical fibre Bragg grating (FBG) sensors have significant potential for use as embedded devices to monitor the structural integrity of engineering materials. The main drawback of the FBG strain sensor is its cross-sensitivity to temperature. This paper reports a simple scheme for multiplexing a FBG and an extrinsic Fabry-Perot interferometric (EFPI) sensor to enable the decoupling of strain from temperature. The EFPI sensor was constructed using a precision bore quartz capillary tube which housed two cleaved optical fibres. The gap between the fibre end-faces served as the Fabry-Perot cavity. Since the coefficients of thermal expansion between the optical fibre and the capillary tube were similar, the EFPI sensor has a very low sensitivity towards temperature. Therefore, when both sensors are placed close together, the EFPI sensor can act as the strain sensor, and temperature can be determined from the FBG wavelength shift after taking out the strain effect. The signal processing for the EFPI sensor was based on a channelled spectrum method using a CCD spectrometer. The same CCD spectrometer was also used to determine the wavelength shift of the FBG. The cross-talk between the EFPI and FBG sensors was evaluated. The feasibility of conducting simultaneous strain and temperature measurements was demonstrated.

Simultaneous Measurement of the Temperature and Force Using A Steel Cantilever Soldered with A Partially Nickel Coated In-Fibre Bragg Grating

Simultaneous Measurement of Pressure and Temperature Using a Single Fiber Bragg Grating

Simultaneous measurement of temperature and force based on a special-strain-function-chirped FBG

Simultaneous Force and Temperature Measurement Using S Fiber Taper in Fiber Bragg Grating

Fbg-Type Sensor for Simultaneous Measurement of Temperature and Force Based on Reflection Spectrum Broadening

Simultaneous Measurement of Temperature and Pressure by a Single Fiber Bragg Grating with a Broadened Reflection Spectrum.

Displacement and Temperature Simultaneous Measurement with Single Fiber Bragg Grating

Ultrasensitive Parallel Double-Fpis Sensor Based on Vernier Effect and Type II Fiber Bragg Grating for Simultaneous Measurement of High Temperature and Strain

Simultaneous Measurement of Temperature and Pressure using a Single Fiber Bragg Grating Based on Reflected Wave′s Broadened Bandwidth

Simultaneous Independent Temperature and Strain Measurement Using One Fiber Bragg Grating Based on the Etching Technique

Temperature-insensitive Fiber Bragg Grating Force Sensor Via a Bandwidth Modulation and Optical-Power Detection Technique

A Novel Temperature-Independent Double Fiber Bragg Grating Strain Sensor

A Novel High-Sensitivity Fiber Grating Sensor for Simultaneous Measurement of Temperature and Pressure

Simultaneous Strain and Temperature Measurements in Composites Using A Multiplexed Fibre Bragg Grating Sensor and an Extrinsic Fabry-Perot Sensor

Simultaneous Measurement of Temperature and Strain Using Spheroidal-Cavity-Overlapped FBG

Simultaneous measurement of temperature and strain using double-cladding fiber based hybrid Bragg grating

A Temperature-Independent Force Transducer Using One Optical Fiber with Multiple Bragg Gratings.

Simultaneous Strain and Temperature Measurement Using an Integrated Fibre Bragg Grating Extrinsic Fabry-Perot Sensor

Simultaneous Displacement and Temperature Measurement Using One Fiber Bragg Grating

Simultaneous Measurement of Temperature and Strain by Combining a Fiber Bragg Grating and the Pigtail Fiber Covered with Epoxy Resin

Simultaneous Force and Temperature Measurement Using Long-Period Grating Written on the Joint of A Microstructured Optical Fiber and A Single Mode Fiber