Abstract:Wake vortex evolution of a square cylinder with a slot synthetic jet issuing from the cylinder’s rear surface has been experimentally investigated using the time-resolved particle image velocimetry technique. The Reynolds number based on the side length of the square cylinder is $Re=836$. The excitation frequency normalized by the natural shedding frequency $f_{e}/f_{0}$ varies from 0 to 6 at the dimensionless stroke length $L_{0}/w=72.6$. The distributions of the time-averaged Reynolds stresses present significant differences as the excitation frequency increases. With control, the mean streamwise velocity deficit of the wake recovers more quickly in comparison with the natural case, and the vertical velocity fluctuation intensity becomes weaker. Moreover, a drag reduction can be achieved for the control cases, especially, for $f_{e}/f_{0}=4$ and $f_{e}/f_{0}=6$, a thrust instead of drag reduction can be obtained. The profiles of the mean streamwise velocity tend to have jet-like distributions. The wake vortex dynamics and its evolution with the excitation frequency are revealed. (i) For the low excitation frequency cases ($f_{e}/f_{0}=0.5$, 1, 2), no significant changes in the dominant frequency and the spanwise vortex structures are observed in comparison with the natural case. (ii) For the moderate excitation frequency case ($f_{e}/f_{0}=3$), the wake vortex shedding frequency is locked on half of the control frequency. In this case, the shear layer is divided into two parts by the synthetic jet vortex, and the wake vortices with smaller scales still shed asymmetrically and appear closer to the square cylinder. (iii) For the high excitation frequency case ($f_{e}/f_{0}=6$), the flow is governed by the synthetic jet. As a result of strong perturbations of the synthetic jet, the wake vortex shedding becomes symmetric with the shedding frequency consistent with the control frequency. And the separation is suppressed effectively. The different control effects of the slot synthetic jet on a square cylinder and a circular cylinder are also compared in detail. Generally speaking, the circular cylinder is easier to be controlled due to its non-fixed separation points.

Synthetic Jet Control of Separation in the Flow over A Circular Cylinder

Control of flow separation over a circular cylinder using synthetic jet

Wake Vortex Evolution of Square Cylinder with A Slot Synthetic Jet Positioned at the Rear Surface

Effects of Micro Blowing/suction Flow Control Devices on a NACA0015 Airfoil

Flow and Heat Transfer Characteristics in a Microchannel with a Circular Synthetic Jet

Square cylinder flow controlled by a synthetic jet at one leading edge

Control of Vortex Shedding from Two Side-by-side Cylinders Using a Pair of Tangential Jets

Lift Augmentation Potential of the Circulation Control Wing Driven by Sweeping Jets

System Identification and Model Predictive Control of Vortex Shedding Behind a Rotating Cylinder

Control of Unsteady Separated Flows Inside Axial Compressors by Synthetic Jets

Separation flow control and engineering application of synthetic jets in compressor

Separation Control Using Synthetic Vortex Generator Jets in Axial Compressor Cascade

Numerical simulation investigation on the suction stroke and blowing stroke of synthetic jet circulation control

Sweeping jet control of flow around a circular cylinder

Active control of the flow past a circular cylinder using online dynamic mode decomposition

Suppression of flow separation around a finite wall-mounted square cylinder by suction at the side leading edge

Flow Control of Annular Compressor Cascade by Synthetic Jets

Effect of Synthetic Jets Actuator Parameters on Deep Reinforcement Learning-Based Flow Control Performance in a Square Cylinder

Sensitivity-aided active control of flow past twin cylinders

Numerical Investigation on Controlling Separated Cascade Flows by Using Jets

Detached-eddy Simulation of Flow Past a Pitching NACA 0015 Airfoil with Pulsed Actuation