Abstract:BackgroundThe impact of power and signal cable harnesses on the dynamic behavior of lightweight space structures has come into the spotlight in the recent past. The previous analytical modelling efforts in this area have primarily focused on either periodically wrapped beam structures or plate structures of parallel cable wrapping patterns. ObjectiveThe presented paper aims at experimental validation for an analytical model developed by the authors for cable harnessed plate structures with periodic patterns such as zigzag and diagonal. The work includes an extensive analysis of the vibration behavior of cable-harnessed plates in comparison to their host plates with no cables attached.MethodsAn energy equivalence homogenization technique is developed to model the vibrations behavior of the cable harnessed plates of periodic patterns. Experimental modal analysis is performed on cable-harnessed plates using impact hammer excitation and laser doppler vibrometry. The natural frequencies, mode shapes, and frequency response functions are obtained for comparisons with the model predictions.ResultsThe impacts of the harnessing cables on plate dynamics are modeled and compared to the experimental frequency response functions for periodically wrapped cabled plates in four different test structures. The impact of the cable wrapping directions along the length and width on the modes that experience the largest stiffening effects are clearly discussed and validated with the test results for the two major wrapping patterns, diagonal and zigzag. It is shown that for a given number of fundamental elements and cable wrapping rows along the length, the parallel pattern experiences the largest stiffening along the length followed by the diagonal and zigzag patterns respectively. Also, the twist mode was stiffened the most for the zigzag pattern and the least in the parallel cabled plate. Finally, the wrapping angle for which the torsional frequency is maximum for each of the diagonal and zigzag patterns is found to be the same. A computational study is also performed to further analyze the system dynamics by varying the host plate dimensions.ConclusionsThe model and test results are shown to be in very good agreement. The analytical model is found to well predict the cables' mass and stiffening effects for all the wrapping patterns studied in this research.

Experimental validation method of elastic thin rod model for simulating the motional cable harness

Model Experiment on the Static Behaviors of a Crescent-Shaped Cable-Truss Canopy Structure

Experimental Analysis of Rod-Cable Deployable Mast System

The Simulation of Cable Harness Based on Mass-Spring Model

Physical Modeling and Configuration Simulation for Constrained Cables of Electromechanical Products

Modeling and Experimental Verification of a Cable-Constrained Synchronous Rotating Mechanism Considering Friction Effect

Configuration Modeling and Experimental Verification with 3D Laser Scanning Technology for a Constrained Elastica Cable

Modeling of transmission characteristics across a cable- conduit system

Tension Optimization of a Cable-Driven Coupling Manipulator Based on Robot Dynamics with Cable Elasticity.

Dynamic Modeling and Experimental Verification of a Cable-Driven Continuum Manipulator with Cable-Constrained Synchronous Rotating Mechanisms

Modeling and Verification of Cable-Hole Transmission Tension Ratio Considering the Cable Lateral Extrusion

Laboratory Testing and Modeling of a High-Displacement Cable Bolt

Quasi-static modeling of a cable-driven continuum manipulator considering non-smooth cable-hole friction and experimental verification

Dynamic Analysis of Umbilical Cables for Maglev Vibration Isolation Systems

Mechanics modeling of spacecraft cable considering spatial constraints

Analysis of Cable under Dynamic Contact and Large Deformation

Vibrations Analysis of Cable-Harnessed Plates: Continuum Modeling and Experimental Validation

Design, Analysis, and Experimental Validation of an Active Constant-Force System Based on a Low-Stiffness Mechanism

Mechanics Modeling and Simulation of Flexible Cable on Spacecraft Considering Spatial Constraints

EXPERIMENTAL STUDY ON VIBRATION MITIGATION OF A STAY CABLE USING NONLINEAR HYSTERETIC DAMPERS

Dynamic Analysis and Experimental Validation of Periodically Wrapped Cable-Harnessed Plate Structures