Abstract:With the aim to enhance the phase shift range and bandwidth of the novel Inverted-E topology for single-bit and multi-bit phase shifters, this work proposes a new structure, wherein the Main Transmission Line (MTL) in the Inverted-E topology is replaced by a tunable transmission line with a fixed open circuited stub loaded at its center point. Therefore, offering four design freedoms, precisely the characteristic impedances and electrical lengths of the transmission line and the fixed open circuited stub, that provides it the flexibility to achieve much smaller susceptance values for large phase shifts up to 180°. The required susceptances are realized using three symmetric open or short-circuited stubs, which are loaded to the tunable transmission line using switching p-i-n diodes. The fixed open circuited stubs ensure excellent circuit matching to the port impedance of in the OFF-state, without the need of any additional matching network. Whereas, the enhanced design flexibility enables the realization of compact dimensions and lower insertion loss. A systematic design procedure is developed, supported by detailed design theory and mathematical formulations, followed by validation through analysis and simulations of typical 22.5°, 45°, 90° and 180° digital phase shifters. For experimental verifications, 90° and 180° designs are manufactured at center frequency of 2.4 GHz and a good agreement is observed with theory and simulations. The results indicate compact dimensions of and , corresponding insertion losses of 1.7 dB and 2.85 dB with phase error less than 1° at center frequency. Moreover, the phase variation is observed to be 2° and 5°, in bandwidths of 400 MHz and 100 MHz respectively.

A single toroid nonreciprocal digital latching ferrite phase shifter in grooved waveguide

An 18~30 GHz Vector-Sum Phase Shifter with Two-Stage Transformer-Based Hybrid in 130-Nm SiGe BiCMOS

An Ultra Broadband Passive Vector Modulator Phase Shifter

An 18 similar to 30 GHz Vector-Sum Phase Shifter With Two-Stage Transformer-Based Hybrid in 130-nm SiGe BiCMOS

29-/35 GHz Dual-band High-Gain Phase Shifter with Hybrid -Networks

Planar Tunable High-Temperature Superconductor Microwave Broadband Phase Shifter with Patterned Ferroelectric Thin Film

FERRITE-LOADED HALF MODE SUBSTRATE INTEGRATED WAVEGUIDE PHASE SHIFTER

Compact and Low Loss Phase Shifter with Low Bias Field Using Partially Magnetized Ferrite

A Ka-band 3-bit RF MEMS switched line phase shifter implemented in coplanar waveguide

A DMTL Phase Shifter Using Insulation Layer and Saw-Shaped CPW

Waveguide power phase shifter with a ferrite circulator in S-band

A novel high-power waveguide phase shifter with continuous linear phase adjustment

A COMPACT PHASE SHIFTER WITH WIDE PHASE RANGE USING LOADED TRANSMISSION LINE

A Ka-band 0/∏ MEMS phase shifter

A Broadband Tunable Multilayer Substrate Integrated Waveguide Phase Shifter

A Novel Design for the MEMS Phase Shifter

Liquid Crystal-Filled 60 GHz Coaxially Structured Phase Shifter Design and Simulation with Enhanced Figure of Merit by Novel Permittivity-Dependent Impedance Matching

Analysis of a fast-acting waveguide ferrite phase shifter with longitudinal magnetization phasing structure

A Ka-band 0/Π MEMS Phase Shifter

Inverted-E Type Phase Shifter Using Fixed Stub-Loaded Main Line: Enhanced Bandwidth and Phase Shift Range

A gap waveguide-based mechanically reconfigurable phase shifter for high-power Ku-band applications