Abstract:A micromixer is one of the most significant components in a microfluidic system. A three-dimensional micromixer was developed with advantages of high efficiency, simple fabrication, easy integration, and ease of mass production. The designed principle is based on the concepts of splitting–recombination and chaotic advection. A numerical model of this micromixer was established to characterize the mixing performance for different parameters. A critical Reynolds number (Re) was obtained from the simulation results. When the Re number is smaller than the critical value, the fluid mixing is mainly dependent on the mechanism of splitting–recombination, therefore, the length of the channel capable of complete mixing (complete mixing length) increases as the Re number increases. When the Re number is larger than the critical value, the fluid mixing is dominated by chaotic advection, and the complete mixing length decreases as the Re number increases. For normal fluids, a complete mixing length of 500 µm can be achieved at a very small Re number of 0.007 and increases to 2400 µm as the Re number increases to the critical value of 4.7. As the Re number keep increasing and passes the critical Re number, the complete mixing length continues to descend to 650 µm at the Re number of 66.7. For hard-to-mix fluids (generally referring to fluids with high viscosity and low diffusion coefficient, which are difficult to mix), even though no evidence of strong chaotic advection is presented in the simulation, the micromixer can still achieve a complete mixing length of 2550 µm. The mixing performance of the micromixer was also verified by experiments. The experimental results showed a consistent trend with the numerical simulation results, which both climb upward when the Re number is around 0.007 (flow rate of 0.03 μm/min) to around 10 (flow rate of 50 μm/min), then descend when the Re number is around 13.3 (flow rate of 60 µm/min).

Mixing enhancement of novel passive microfluidic mixers with cylindrical grooves

Numerical simulation of fluid mixing reinforcement in micro-mixers with barriers embedded

A Novel Passive Micromixer with Modified Asymmetric Lateral Wall Structures

Mixing in T-shaped Micro-Channel Network

Numerical Simulation on Fluid Mixing by Effects of Geometry in Staggered Oriented Ridges Micromixers

A New Micromixer with Helical Microchannel and Research on Its Numerical Flow Field

An Enhanced One-Layer Passive Microfluidic Mixer with an Optimized Lateral Structure with the Dean Effect

Mixing in microfluidic devices and enhancement methods

Mixing enhancement of the passive microfluidic mixer with J-shaped baffles in the tee channel

Design and Experimental Study of Staggered Oriented Ridges Micromixers

Design and Evaluation of an Easily Fabricated Micromixer with Three-Dimensional Periodic Perturbation

Convex Grooves in Staggered Herringbone Mixer Improve Mixing Efficiency of Laminar Flow in Microchannel

Enhancement of passive mixing via arc microchannel with sharp corner structure

Numerical Analysis on a Passive Chaotic Micromixer with Helical Microchannel

A Three-Dimensional Micromixer Using Oblique Embedded Ridges

Efficient Mixing of Microfluidic Chip with a Three-Dimensional Spiral Structure

Numerical Simulation and Structural Recombination of Microchannel Micromixer for Excellent Mixing Performance

A microfluidic nanoliter mixer with optimized grooved structures driven by capillary pumping

An Investigation of Flow Patterns and Mixing Characteristics in a Cross-Shaped Micromixer within the Laminar Regime

A compact and efficient three-dimensional microfluidic mixer