Abstract:Lithium-ion batteries (LIBs) thermal safety issues such as thermal runaway (TR) triggered by thermal or mechanical abuse have been one of the most important factors hindering its development at present. In order to effectively release the excessive pressure caused by TR, a safety vent is used as a reliable safety device in commercial LIBs. However, the current interrupt device (CID) and vent activation behaviour and mechanism are still unclear in the mesoscale. Herein, finite element simulations of metallic material deformation and failure during CID and vent activation at preset dynamic incremental pressure loads and various constant temperatures for a commercial 18650 LIB were carried out by introducing the Johnson-Cook (J-C) damage model in this study. The three-dimensional evolution, dynamical and mechanical analysis of the deformation to damage behaviour are quantitatively characterized. The CID- and vent-activation pressure based on the J-C damage criterion is significantly higher than the pressure value corresponding to the maximum von Mises stress. The results show fracture strain of the burst disk notch and plate will not exceed 0.93 % and 0.048 % respectively when the TR reaches the onset temperature. The temperature-dependent activation time reduction rate was developed to quantify the effect of temperature on the CID-and vent-activation times, indicating that TR temperature's effect on vent activation is significantly stronger than that of CID. These results may provide a reliable guide to LIB safety design.

Study of Influence Factors on Current Limiting Characteristics of Self Pinch Effect Type Liquid Metal Current Limiter

A Novel Liquid Metal Fault Current Limiter Based on Active Trigger Method

Experimental Study on the Solid-state Fault Current Limiter with Bypass Inductance

Hybrid Multifunctional Saturated-core Fault Current Limiter

Research on the dynamic characteristics of the electromagnetic repulsion mechanism of a self-driving fault current limiter

Study on Mathematic Model and Model Simulation of the Three Phase Solid State Fault Current Limiter

Simulation Study of New Solid-State Fault Current Limiter

Development of a Hybrid Fault Current Limiter Using Liquid Metal for Large Capacity MVdc Power Systems

Saturated-core fault current limiters for AC power systems: Towards reliable, economical and better performance application

A Novel Six-Leg Three-Phase Fault Current Limiter

Investigation of a Double Current-transferring Type Short Circuit Current Limiter

Short Circuit Current Limiter in As Network

Design and Test of a Magnetic Saturation‐type Fault Current Limiter

Study on Control Strategy of the Three Phase Solid State Fault Current Limiter with Parallel Connected Inductance

Research of a New Type Permanent Magnet Magnetic Saturation Fault Current Limiter

Analysis of the Energy Dissipation Characteristic in an MMC-Based MVDC System With the Liquid Metal Current Limiter

Design Improvement of Fault Current Limiter Based on High Coupled Split Reactor Considering the Impact of Internal Ground Fault

Research of fault-current limiter for three-phase four-wire power system

Thermal Runaway-Induced Current Interrupt Device and Vent Activation Behaviour in an 18650 Lithium-Ion Battery Cap Using the Johnson-Cook Criterion

A Novel Multi-Function Saturated-Core Fault Current Limiter

Effects of fault current limiter on the safety and stability of power grid and its application: A research review