Abstract:A series of tests were conducted using scattered laser light photography to study the spray characteristics of DME and diesel fuel. The photographs show that, compared with diesel fuel, DME spray displays a slower penetration, much faster evaporation, and a wider spray angle by a factor of about 2, although its general appearance is similar to that of diesel spray. Another series of tests were performed with shadow photography, in which the detailed DME spray characteristics were investigated. The results of high-speed photography show that the spray breakup time of DME is 0.2∼0.4ms, which is shorter than that of diesel fuel. Increasing the ambient density resulted in a shorter breakup time, a wider spray angle, and rapid reduction in the spray penetration and spray tip velocity. With decreasing the orifice diameter, both the spray penetration and the spray angle decrease. The results show that the needle valve opening pressure almost has no effect on the DME spray penetration. Decreasing the needle valve opening pressure leads to a decrease in the spray angle at the beginning of the spray development, but it almost has no effect at the end of spray development. Testing was also run in engine-like ambient temperature ranging from 573K∼773K, in which no big change in the spray penetration was found with increasing either the ambient temperature or the ambient density. The James model was used to investigate the mixing characteristics of DME spray. The calculation results agreed well with the experimental results, and showed that the DME spray has a higher air fuel equivalence ratio than diesel spray, indicating a better mixing with air in DME spray. This is one reason that DME emits low pollutant emissions. Also, the calculation results showed that increasing the ambient density or decreasing the orifice diameter would cause an increase in the air fuel equivalence ratio of DME spray. Copyright © 2001 Society of Automotive Engineers, Inc.

Investigation of Dimethyl Ether Injection Process and Influencing Factors

Study on injection characteristics of diesel and DME

An Investigation on Injection Process of Dimethyl Ether

Fuel Injection System Simulation for DME Engine

Experimental Investigation on Injection and Combustion of Dimethyl Ether Fueled Diesel Engine

Investigation of the Injection Process and Combustion of A Dimethyl Ether Engine with Different Nozzle Flow Areas

Simulation on Diesel/DME Mixed Injection System

An Investigation on Combustion and Exhaust Emissions of Direct Injection Diesel Engine Fuelled with Dimethyl Ether

Effects Of Fuel Temperature On Injection Process And Combustion Of Dimethyl Ether Engine

An Investigation on the Combustion Characteristics of Dimethyl Ether (DME)

Study on the performance and emissions of a compression ignition engine fuelled with dimethyl ether

Experimental Study of the Influence of Injection Parameters on the Spray and Combustion Process of Dimethyl Ether

Study of Combustion Characteristics of a Compression Ignition Engine Fuelled with Dimethyl Ether

Numerical Investigations of Injection Timing Effects on a GDI Engine Performance: Part B, In-Cylinder Emission Formation and Oxidation Process

An Experimental Study of the Dimethyl Ether (DME) General Spary Characteristics

Study on Combustion Characteristics of DME Fueled Diesel Engine

Investigation on the regulated and unregulated emissions of a DME engine under different injection timing

Experimental and Numerical Study of Methanol/Dimethyl Ether Dual-Fuel Compound Combustion

Study on Combustion and Emission Characteristics of a Vehicle Engine Fuelled with Dimethyl Ether

Experimental Study on the Combustion Process of Dimethyl Ether (DME)

An experimental investigation on the spray characteristics of dimethyl ether(DME)