The Combustion Characteristics of Vehicular Turbocharged Dimethyl Ether Engine
Jun-jun ZHANG,Xin-qi QIAO,Jun-hua WU,Jun LU,Liang ZHANG,Zhen HUANG,Xin-yu LI
DOI: https://doi.org/10.3321/j.issn:1006-2467.2006.08.010
2006-01-01
Shanghai Jiaotong Daxue Xuebao/Journal of Shanghai Jiaotong University
Abstract:Experimental study was conducted with a vehicular turbocharged diesel engine fueled with neat dimethyl ether (DME). The combustion analysis on DME and diesel engine was carried out according to the heat release rate (HRR) calculated from measured p-φ diagrams and other performance parameters. The results show that, with increasing engine speed under the full part load, the fuel consumption decreases firstly, and then increases, the exhaust temperature is firstly up and downward later, finally upward again. At the rated power, the HRR for each engine has only one peak, peak pressure and rate of pressure rise for DME engine is lower comparatively. With increasing loads the diagram of HRR evolves from two peaks to mono-peak. With increasing engine speed under the same mean effective pressure, the ignition timing delay, and the weight center of HRR diagram is gradually away from TDC. DME engine with an injector of six holes has a good performance due to faster diffusion combustion. With the increment of fuel delivery advance angle at the rated power, the ignition timing, the peak HRR and the weight center of HRR diagram are all near to TDC, and the fuel consumption becomes lower gradually, while the peak HRR main-tains the same level.