Abstract:Large-mode-area photonic crystal fiber is used to generate high power, high beam quality supercontinuum. Propagation and supercontinuum generation process of laser pulse in large-mode-area (LMA) photonic crystal fiber (PCF) is simulated by solving the general nonlinear Schrödinger equation (GNLSE) using the split-step Fourier method. Effects of the pump pulse parameters (peak power and chirp) and the length of photonic crystal fiber used on supercontinuum generation are particularly estimated. Nonlinear spectral broadening mechanism of laser pulse in large-mode-area photonic crystal fiber is discussed. The results show that the process of supercontinuum generation can be divided into three stages: initial broadening, dramatic broadening and saturation broadening. The spectrum width and efficiency can be achieved by the optimized length of LMA PCF to insure output of the generated supercontinuum at the dramatic broadening stage. The pump peak power and chirp have important impact on supercontinuum generation. When a small peak power pump is input, the spectrum broadens symmetrically. When the pump peak power increases, it brings little changes with the shorter wavelength component but broader of the longer wavelength component. The time-domain shape of the pulse exhibits concussion modulation as the effect of pulse breakup. When the pump chirp is positive, little influence is shown, except a shift of longer wavelength power by increasing the chirp. But the full width of the supercontinuum has little changes. While the pump chirp is negative and satisfy certain condition, the nonlinear is enhanced to facilitate the supercontinuum generation.

Wavelength Tunable, High Energy Femtosecond Laser Pulses Directly Generated from Large-Mode-area Photonic Crystal Fiber

Vector-dispersion Compensation and Pulse Pedestal Cancellation in a Femtosecond Nonlinear Amplification Fiber Laser System.

Femtosecond Mode-locked Fiber Laser at 1 Μm Via Optical Microfiber Dispersion Management

High-energy femtosecond Yb-doped fiber laser operating in the anomalous dispersion regime

Old Wavelength, New Performance: Hectowatt 200-μJ-level Femtosecond fiber CPA System at 1064 Nm

Self-phase modulation enabled, wavelength-tunable ultrafast fiber laser sources: an energy scalable approach.

Fiber-Based High-Energy Femtosecond Pulses Tunable from 920 to 1030 Nm for Two-Photon Microscopy

High-energy Femetosecond Er3+-doped Fiber Laser

High energy, single-polarized, single-transverse-mode, nanosecond pulses generated by a multi-stage Yb-doped photonic crystal fiber amplifier

Generation of high-energy self-mode-locked pulses in a Tm-doped fiber laser

Femtosecond Yb-doped Tapered Fiber Pulse Amplifiers with Peak Power of over Hundred Megawatts

Tailored Multi-Color Dispersive Wave Formation in Quasi-Phase-Matched Exposed Core Fibers

Pulse Energy Scaling by Optimizing Cavity Management in Low Repetition Rate Erbium-Doped Fiber Femtosecond Lasers

Photonic Crystal Fiber Based Wavelength-Tunable Optical Parametric Amplifier and Picosecond Pulse Generation

High-energetic ultrafast fiber laser sources tunable from 920 to 1030 nm based on tapered photonic crystal fibers

Supercontinuum generation and control from large-mode-area photonic crystal fiber

High Energy, Monolithic Fiber Femtosecond Lasers

High-energy femtosecond pulse generation from a hybrid mode-locked large-mode-area Er:ZBLAN fiber laser

High-Power GHz Burst-Mode All-Fiber Laser System with Sub 300 fs Pulse Duration

Widely tunable sub-30-fs pulses from a compact erbium-doped fiber source

High-energy femtosecond Yb-doped dispersion compensation free fiber laser