Determination of Optimal Identity Points for Backcalculating the Structural Layer Moduli of Asphalt Pavement
Yue Hu,Guoshuai Zang,Lijun Sun,Liping Liu,Huailei Cheng
DOI: https://doi.org/10.1360/tb-2020-0094
2020-01-01
Chinese Science Bulletin (Chinese Version)
Abstract:The backcalculated structural moduli of asphalt pavement using the falling weight deflectomer (FWD) deflection basin data has been increasingly used for evaluating the bearing capacity of non-destructive pavement structures. The current backcalculation methods can be divided into 2 categories, i.e., one algorithm based on deflection basin matching and the other algorithm based on deflection basin law. The principle of the former algorithm is to find a set of structural layer moduli so that the theoretical deflection and the measured deflection have the highest matching degree, and the later algorithm uses some regular and special points according to the law of the deflection basin affected by the structural parameters to backcalculate layer moduli. Research has shown that the former algorithm has a problem in whether there is a unique solution and the inversion efficiency. While the basin law algorithm is able to generate a unique solution, which makes it more suitable for engineering applications. However, the identity points used in the current basin law algorithm were determined based on the theoretically calculated FWD deflection basins. The accuracy of these identity points needs to be further validated using the field measured FWD data. Therefore, in order to determine the optimal positions of the identity points accurately, this paper analyzed the law of backcalculated moduli of pavement structure based on the measured layer-by-layer deflection basins of different pavement structures. First of all, the influence of different identity points on the backcalculated base moduli was investigated using the deflection data from the full scale testing track of RIOH. Then, the optimal positions of the identity points were determined, based on the principle of the consistency of the backcalculated base modulus using the measured deflection basin data, which means that the backcalculated modulus values of base layers should be almost the same. Finally, the accuracy of the optimization identity point method was verified by independent deflection data. The results indicated that the positions of identity points had significant effects on the backcalculated moduli for the base layer. When the position of the base identity point was unchanged, the variability of the backcalculated base modulus tended to decrease first and then increase as the position of the surface identity points as far away from the load center. And according to the deflection data from the full scale testing track of RIOH, we concluded that, for the two-layers asphalt pavement, when the optimal position of the identity point was 30 cm far from the load center while the positions for three-layers asphalt pavement were 0 and 60 cm away from the load center, the backcalculated base modulus based on layer-by-layer deflection data had the best consistency. Based on the inversion analysis of the independent deflection data, the accuracy of the position of the identity points determined in this study was verified. The verification results showed that the modified method proposed in this study could be used to accurately backcalculate the modulus of the pavement structure layer in other engineering, and the method was highly applicable. At the same time, the method proposed in this study had stable results and low variability, which can meet the needs of engineering.